Table of Contents
Advertisement
Appendix
FCC, ACTA and IC regulations
IC (Industry Canada)
This telephone is registered for use in
Canada.
The term "IC:" before the radio certification
number only signifies that Industry Canada
technical specifications were met.
Notice: This equipment meets the applicable
Industry Canada Terminal Equipment
Technical Specifications. This is confirmed by
the registration number. The abbreviation, IC,
before the registration number signifies that
registration was performed based on a
Declaration of Conformity indicating that
Industry Canada technical specifications were
met. It does not imply that Industry Canada
approved the equipment.
Notice: The Ringer Equivalence Number
(REN) for this terminal equipment is 0.7. The
REN assigned to each terminal equipment
provides an indication of the maximum num-
ber of terminals allowed to be connected to a
telephone interface. The termination on an
interface may consist of any combination of
devices subject only to the requirement that
the sum of the Ringer Equivalence Numbers
of all the devices does not exceed five.
Before installing this equipment, users should
ensure that it is permissible to be connected
to the facilities of the local telecommunica-
tions company. The equipment must also be
installed using an acceptable method of con-
nection. The customer should be aware that
compliance with the above conditions may
not prevent degradation of services in some
situations.
Repairs to certified equipment should be
made by an authorized Canadian mainte-
nance facility designated by the Supplier. Any
repairs or alterations made by the user to this
equipment, or equipment malfunctions, may
give the telecommunications company cause
to request the user to disconnect the equip-
ment.
Users should ensure for their own protection
that the electrical ground connections of the
power utility, telephone lines and internal
metallic water pipe system, if present, are
connected together. This precaution may be
particularly important in rural areas.
Caution:
Users should not attempt to make such con-
nections themselves, but should contact the
appropriate electrical inspection authority or
electrician as appropriate.
Your Cordless Phone is designed to operate
at the maximum power allowed by the FCC
and IC. This means your Handset and Base
Unit can communicate only over a certain dis-
tance — which will depend on the location of
the base unit and handset, weather, and the
construction and layout of your home or
office.
13
Advertisement
Table of Contents
