Installation Of Battery Pack In Handset - Gigaphone sbc2432 Owner's Manual

Installation of Battery Pack in Handset

1
The original Handset that is shipped with your GIGAPHONE system will be
automatically registered to the Base. This Handset is HANDSET 1.
As you register additional Handsets to the system, they will be assigned extension
numbers in the following order: HANDSET 2, HANDSET 3, and finally
HANDSET 4.
Whenever a Handset battery pack is installed, the Handset will automatically
begin SEARCHING FOR BASE (if previously registered), or it will prompt
you to ENTER BASE ID to register the new Handset.
Follow the steps below:
1.
Remove the battery cover by
pressing on the indent and
sliding downward.
2.
3
Place the new battery pack in the
handset with the metal contacts
aligned with the charge contacts
in the battery compartment.
3.
Replace the battery cover by
sliding it upwards.
4.
If the new battery pack is not
already charged, place the
handset in the base unit, or a
remote charging stand, and allow
it to charge for 12 hours. After
initial charge, a maintenance
charge of 8 hours should be
sufficient.
2
8