Using Your Humidifier; Operating Tips For Best Performance; Instrucciones Generales De Seguridad - Kenmore 758.144162 Operator's Manual

Using Your Humidifier
Step 1:
Be sure humidifier is full of water and
plugged in.
Step 2:
Set Speed Control " I_ " to lowest
speed ".".
Step 3:
Set Humidity Control " _ " to medium
position.
NOTE: Humidifier should operate with
humidity control on the recommended
medium setting. If it does not, the
humidity is at a relatively high level.
To test the unit under this condition, turn
Humidity Control all the way to clockwise
and unit should begin to operate. After
the unit has been tested, set Humidity
Control to medium or desired level.
Allow 24 hours for humidifier to adjust.
If humidity level in home is sufficient, the
humidifier will only operate with Humidity
Control turned all the way clockwise.
IMPORTANT: Water damage may result
if condensation starts to form on windows
or walls. Humidity Control setting should
be lowered until condensation no longer
forms.
Step 4:
If humidifier stops running and the unit is
not empty, the humidity level is at the
normal requirements for that setting or it
is adjusting to the home conditions. The
table below shows recommended indoor
humidity levels. The figure shows
approximate relative humidity
percentages which correspond to the
various settings of the Humidity Control.
When Outdoor
Temperature is:
-10°F
0°F
10°F
20°F
Recommended Indoor
Relative Humidity is:
20%
25%
30%
35%
ReZ,!,
'-)
_a
Operating Tips for Best Performance
1. Position the humidifier at least 2 inches
from any wall and away from any heat
registers.
2. Do not restrict airflow from entering or
exiting the humidifier.
3. Use Sears recommended bacteriostat
32-14900 to retard bacteria growth
that may cause odors and may be
harmful to your health.
4. Perform regular cleaning as instructed
in "Cleaning and Maintenance" section
of this manual.
5. Replace the evaporative wicking filters
at least once per humidification
season or more depending on water
conditions in your area.