Cutting With A Nylon Head - Ducati DBC 5201T Owner's Manual

WARNING
Before using, please check the shoulder harness
and confirm it is OK. If in danger, please stop the
brush cutter immediately,and pull the quick-relea-
se latch tab, the brush cutter will separate from
your body.
5.To quickly detach the brush cutter from the
harness,pull the quick-release latch tab
upward;
6.Insert the latch tongue in the slot of the
quick-release latch to reattach the brush
cutter to the harness.

9. CUTTING WITH A NYLON HEAD

Line head rotates in a counter CLOCKWISE
direction.The CUT-OFF KNIFE will be on the
right side of the debris shield
DANGER The proper debris shield must be in place on
the unit when nylon cutting line is used. The
cutting line can flap around if too much line is
exposed. Always use the plastic debris shield
with cut-off knife when using nylon cutting
heads.
Tilting the head to the wrong side will shoot the
debris TOWARDS you.If the line head is held
flat to the ground so that cutting occurs on the
whole line circle, debris will be THROWN at
you, drag will slow the engine down, and you
will use up a lot of lines.
Use only quality nylon monofilament line of the
diameter 2.5mm. Never use wire or wire-rein-
forced line in place of nylon trimmer line. Load
English
Owner's manual
33
33