Table of Contents
Advertisement
5. DIRECTIONS FOR USE
5-2-2.
Operation
1) The trace line should appear at the center of the CRT
screen. If it doesn't, adjust it as necessary with the -
knob. Next, adjust the INTENSITY and FOCUS knobs to
give a clear, easily-viewable trace.
2) Apply an input signal to the INPUT terminal and adjust
the ATT and SWEEP RANGE to bring the waveform to
the appropriate size.
5-3.
MONITOR SCOPE FUNCTION
5-3-1.
Hook-up
Note:
:
Since the TRIGGER unit uses a FIX circuit, there is no
need for the usual complex trigger manipulations. Due
to use of the FIX circuit, however, synchronization
may become impossible to achieve for wave forms
which, for example, differ radically in duty ratio.
Caution:
lf the SM-230 is placed near a linear amp or other
device that tends to emit flux easily, the beam may
exhibit some rocking.
Antenna or dummy load.
Figure 5. Hook-up of transmitting monitor
Attention:
Be sure that the transceiver GND and the monitor GND
are connected over as short a distance as possible.
11
Advertisement
Table of Contents
