Troubleshooting - Electrolux EKC7011BOW User Manual

11.7 Replacing the lamp
WARNING!
Risk of electric shock.
The lamp can be hot.
1. Turn off the oven. Wait until the oven is
cold.
2. Disconnect the oven from the mains.
3. Put a cloth on the bottom of the cavity.
The back lamp
The lamp glass cover is at the back of
the cavity.
1. Turn the lamp glass cover
counterclockwise to remove it.
2. Clean the glass cover.
3. Replace the oven lamp with a suitable
300 °C heat-resistant oven lamp.
Use the same oven lamp type.
4. Install the glass cover.

12. TROUBLESHOOTING

WARNING!
Refer to Safety chapters.
12.1 What to do if...
Problem
You cannot activate the appliance.
You cannot activate the appliance.
Residual heat indicator does not
come on.
The oven does not heat up.
The oven does not heat up.
The lamp does not operate.
11.8 The drawer
Do not put food inside the drawer.
Do not keep flammable items such as
cleaning materials, plastic bags, oven
gloves, paper, cleaning products,
aerosols, plastic items) in the drawer.
When you use the oven, the drawer can
become hot. There is a risk of fire.
The drawer below the oven can be removed
for cleaning.
Removing the drawer:
1. Pull the drawer out until it stops.
2. Lift the drawer slightly, so that can be
To install the drawer, follow the procedure in
reverse.
Possible cause
The appliance is not connected to
an electrical supply or it is connec‐
ted incorrectly.
The fuse is blown.
The zone is not hot because it oper‐
ated only for a short time.
The oven is deactivated.
The necessary settings are not set.
The lamp is defective.
WARNING!
WARNING!
lifted upwards at an angle of the drawer
guides.
Remedy
Check if the appliance is correctly
connected to the electrical supply.
Make sure that the fuse is the cause
of the malfunction. If the fuse is
blown again and again, contact a
qualified electrician.
If the zone operated sufficiently long
to be hot, speak to an Authorised
Service Centre.
Activate the oven.
Make sure that the settings are cor‐
rect.
Replace the lamp.
ENGLISH 25