Table of Contents
Advertisement
24
www.aeg.com
'AutoDose configuration mode' how to
change the basic setting, but before:
1. Identify the water hardness level.
Check the water hardness level in
your area. The levels are generally
indicated as: soft, medium and hard.
If necessary, please contact your
local water authority to check the
water hardness in your area.
2. Identify the customized detergent
dosage.
Check the label in the detergent/
fabric softener container and identify
Water hardness levels
Levels
Soft
4)
Medium
Hard
1) French degrees
2) German degrees
3) English degrees
4) Factory setting, able to satisfy most of the use conditions.
10.4 AutoDose configuration
mode
Enter the AutoDose
configuration mode before
proceeding with any
programme setting. The
configuration mode may
cancel temporary settings .
1. Press the On/Off button for a few
seconds to activate the appliance.
2. Wait about 10 seconds for appliance
internal check.
3. To enter in configuration mode, hold
pressed the Temperature and the
Spin buttons simultaneously for a few
seconds until
detergent tank
indicators appear in the display.
After 10 seconds without interacting
with control panel the appliance exits
the configuration mode.
Water hardness range
1)
°f
°d
<15
<8
15 - 25
8 - 14
>25
>14
and the blinking
and softener tank
the quantity to use. The suggested
quantity is the combination of three
different factors:
• Water hardness level (see the
following table);
• Normal soil level;
• Rated capacity of the appliance
(e.g. maximum load capacity 9.0
kg). If the rated capacity on the
product container refers to lower
capacity appliances, the
customized dosage should be
increased.
2)
3)
°e
<10
0 - 17
>17
4. Touch related tank buttons to toggle
function off and on. The display
shows OFF when a tank is disabled
or shows tank indicator when it is
enabled.
mmol/l
ppm
<1.4
<140
1.5 - 2.5
150 - 250
>2.5
>250
Advertisement
Table of Contents
