Table of Contents
Advertisement
All manuals and user guides at all-guides.com
FCC-B rAdio FrEQuENCy iNtErFErENCE StAtEMENt
this equipment has been
tested and found to comply
with the limits for a class B
digital device, pursuant to
part 5 of the FCC rules.
these limits are designed to provide reasonable protection against harmful in-
terference in a residential installation. this equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with
the instruction manual, may cause harmful interference to radio communications.
however, there is no guarantee that interference will occur in a particular instal-
lation. if this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the measures
listed below.
reorient or relocate the receiving antenna.
increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/ television technician for help.
Notice
the changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
Notice
Shielded interface cables and A.C. power cord, if any, must be used in order to
comply with the emission limits.
Voir LA NotiCE d'NStALLAtioN AVANt dE rACCordEr Au rESEAu.
Micro-Star international
MS-7808
this device complies with part 5 of the FCC rules. operation is subject to the
following two conditions:
() this device may not cause harmful interference, and
() this device must accept any interference received, including interference that
may cause undesired operation.
4
Advertisement
Table of Contents
