Table of Contents
Advertisement
Fault
The drying time is too
long.
Water is leaking from
the appliance.
The laundry is too
damp.
Cause and troubleshooting
Ventilate the appliance's installation location.
▶
The appliance's ventilation opening is blocked.
Ensure that the ventilation opening of the appliance
▶
is kept clear.
Heat exchanger is soiled.
Running the basic appliance care programme on
▶
the appliance.
→ "Appliance care", Page 41
Appliance is not correctly aligned.
→ "Aligning the appliance", Page 16
▶
Water drain hose is not connected correctly.
Ensure that the water drain hose is connected cor-
▶
rectly.
→ "Connecting the water drain hose", Page 14
Unsuitable programme for the type of fabric.
Set a timed programme for the subsequent drying.
▶
→ "Programmes", Page 28
There has been a power cut.
Check whether the lighting in your room or other
▶
appliances are working.
The load is too large.
Observe the maximum load capacity of the
▶
→ "Programmes", Page 28.
After the end of the programme, warm laundry feels
damper than it actually is.
Remove the laundry from the drum as soon as the
1.
drying programme has finished.
Spread the items of laundry for cooling.
2.
Unsuitable dryness level set.
→ "Changing the dryness level", Page 27.
▶
Drying target not adjusted.
→ "Adjusting the dryness level", Page 27.
▶
Load too small.
Set a timed programme for the subsequent drying.
▶
→ "Programmes", Page 28
Moisture sensor dirty.
→ "Cleaning the moisture sensor", Page 44.
▶
The drying process is interrupted and the condensa-
tion tank has been filled.
Troubleshooting en
49
Advertisement
Table of Contents
