Table of Contents
Advertisement
¡ If you are using the intelligent dos-
ing system, do not add additional
detergent or fabric softener into
the compartment for manual dos-
ing. This is to prevent overdosing
or foam formation.
Pull out the detergent drawer.
1.
Open the lid.
2.
Pour liquid detergent
3.
softener
into the relevant dis-
pensers → Page 18.
Do not exceed the marking for the
maximum fill level when filling.
Close the lid.
4.
Note: To prevent the liquid deter-
gent or fabric softener from drying
out, close the lids immediately
after filling.
Push in the detergent drawer.
5.
and fabric
Intelligent dosing system en
15.2 Using the manual dosing
compartment
If you are not using the intelligent
dosing system, if intelligent dosing is
not possible for a programme, or if
you want to add additional care
product, e.g. stain remover or starch,
use the manual dosing compartment.
Note: Observe the information about
detergents and care products
→ Page 29.
Pull out the detergent drawer.
1.
Pour laundry detergent or care
2.
product into the manual dosing
compartment → Page 18.
Push in the detergent drawer.
3.
15.3 Setting the basic dosage
amount
To allow for intelligent dosing, set the
basic dosage amount for the dis-
penser. The basic dosage amount
corresponds to the dosage recom-
mendation from the detergent manu-
facturer on the packaging. Set the
basic dosage amount that corres-
ponds to the dosage recommenda-
tion for 4.5 kg of normally soiled
laundry. In doing so, note the water
hardness.
Press and hold i-DOS for ap-
1.
prox. 3 seconds.
a The display shows the basic
dosage set for .
To set the basic dosage for
2.
press i-DOS.
To adjust the setting, press
3.
minado en / em.
Wait briefly to save the setting.
4.
,
Ter-
33
Advertisement
Table of Contents
