Table of Contents
Advertisement
Chapter 02
Preparations
Installation
Attaching the Stand
― Before assembling the product, place the product down on a flat and stable surface so that the screen is facing downwards.
― Disassembly is the reverse order of assembly.
3
Push the assembled stand into the main body in the direction of the arrow
as shown in the figure.
Confirm that the handle is tightly fastened. If the handle has not been fully
lowered, hold it with your hand and lower it.
1
Put the stand base onto the stand neck
Tightly fasten the connecting screw at
as the direction shown in the figure.
the bottom of the stand base. Fasten
Check that the stand neck is firmly
the large screw in the middle for
connected.
assembly.
4
Stand up the monitor as shown in the
Stand assembly is complete.
figure.
2
5
Caution
Do not arbitrarily remove the panel film.
If not observed, the warranty service
may be restricted.
9
Advertisement
Table of Contents
