Vizio VX37L User Manual page 30

d. The screen will now change to
show the progress of the search
for Analog (NTSC) and Digital
(ATSC) channels.
Note: DTV digital broadcast is not available in all
areas. Refer to www.antennaweb.org
information about availability in your area, type of
antenna and in which direction to point your
antenna. The channel availability through cable
depends upon which channels your cable operator
supplies in Clear QAM; consult your cable
operator for more information.
e. When finished, the Complete
screen will be displayed to inform
that the HDTV has completed the
Initial Setup.
Press the
control to exit and begin watching
TV.
5. Select Input Source
Select the Input Source for the HDTV by pressing the
INPUT button on the side of the TV or using the Input
button on the remote control. Pressing this button will
cycle you through the following options: TV, AV1, AV2 (S-
VIDEO), Component1, Component2, RGB, HDMI1 and
HDMI2.
Now follow the procedure below to display channels
from a different signal (External TV Tuner, VCR, Cable
Box or Satellite Receiver) source, using different inputs at
the back of you TV set.
a. Select the correct input connection; RF (DTV/TV)
connector, Composite (Yellow, Red and White)
connectors, Component (Red, Green, Blue plus Red
and White) connectors, HDMI connectors or
Separate-Video (S-Video) plus Red and White
connectors (if applicable). Make the physical connection or hook up.
b. If you have an HD service you must use the HDMI (best) or Component (better) connection.
Note: Composite (AV) and S-Video Cables can only be used for SD (480i) pictures.
Version 11/19/2007
for
button on the remote
30
www.VIZIO.com
VIZIO VX37L HDTV20A User Manual