Table of Contents
Advertisement
Before switching on the TV, put your decoder and media recorder to Standby if they are connected and
ensure the aerial is connected to your TV. To set up the TV, use the buttons on the remote control as
IMPORTANT: Ensure that the aerial is connected and
a Common Interface module is not inserted before
switching on the TV for the first time installation.
1. Connect the mains plug and switch the TV to
using
the
button. If the TV does not switch on,
/ I
press any numbered or
control, then the language selection menu will
be displayed. This screen will appear the first
time that the TV is switched on and each time
the TV is reset.
2. By pressing Up or Down button, highlight the
language you want to set and press OK button.
The following message will be displayed next:
3. By pressing Left or Right button, select the
country you want to set and press Down button
to highlight the Search Type option. Use Left or
Right to set the desired search type. Available
search types are digital only, analog TV only
and full.
4. When set, press Down button to highlight
Teletext Language. Use Left or Right button to
select desired language region. Highlight Scan
Encryted Channels and enable/disable this
option by using Left or Right buttons. Press OK
to continue.
Initial Installation
detailed on
on
button on the remote
English - 13 -
page
7.
Note: Depending on the Country selection you may
be asked to set and confirm a PIN at this point. The
selected PIN cannot be 0000. You have to enter it if
you are asked to enter a PIN for any menu operation
later.
5. The following message will be displayed next on
the screen:
Select Store mode if the TV will be placed in a
store to exhibit. This option will configure your
TV's settings for best display quality and the
supported features of the TV will be displayed
on the top of the screen as a info banner.
If Store mode is selected, a confirmation
screen will be displayed. Select YES to
proceed. For home use select Home Mode.
This option will be available in Other Settings
menu and can be turned off/on later..
6. Press OK button on the remote control to continue
and the following message will be displayed on
the screen:
7. Select Yes button by using Left or Right button
and press OK button to continue. Afterwards, the
following OSD will be displayed on the screen:
8. If you select Cable option, a confirmation screen
will be displayed. If you want to search for
available networks, select YES to proceed. The
following screen will be displayed:
Advertisement
Table of Contents
