Advertisement
en-us_main.book.book Page 12 Tuesday, October 31, 2023 10:48 AM
12 INSTALLATION
4
Center the rear wall template
by lining up the plumb line on the wall with
the centerline on the template. Then securely
tape or tack the rear wall template in place.
Make sure the minimum width is 30 inches
and that the top of the rear wall template is
located a minimum of 30 inches above the
cooking surface.
Measure the bottom of the upper cabinet
frame. Trim edges A, B, and C on the upper
cabinet template
a
fit on the bottom of the upper cabinet. If the
upper cabinet has a recessed frame, trim the
template so it fits inside the recessed area. If
needed, the template can be trimmed inside
the printed trim lines, as long as you are able
to align the centerline correctly. Align the
centerline of the upper cabinet template with
the centerline of the rear wall template, then
securely tape or tack the upper cabinet
template in place.
WARNING
• To avoid risk of personal injury, electric shock or
death:
- Note where electrical outlets and electrical
wires are before you drill into the wall.
- Locate and disconnect power to any electrical
circuits that could be affected by installing this
oven.
• To avoid risk of personal injury, electric shock or
death, cover the edge of the power supply cord
hole with the power supply cord bushing.
Drill Holes in Wall and Cabinet
1
Drill holes on the circles. If there is a stud, drill
a 3/16" hole for lag screws. If there is no stud,
drill a 3/4" hole for toggle bolts. Make sure to
use at least 1 lag screw in a stud, and 2 toggle
screws in the drywall or the plaster.
in the space
b
so that the template will
2
Drill a 3/8" hole at points J and K on the upper
cabinet template.
If the bottom of the upper cabinet is recessed
3/4" or more, you will need 2"x 2" filler blocks
(not included) to provide additional support
b
for the bolts.
Cabinet front
a
Cabinet bottom shelf
c
Mark the center of each filler block and drill a
3/8" diameter hole at the marks.
Align filler blocks
over the two openings in
b
the top of the microwave oven cabinet and
attach to the cabinet with masking tape.
3
Cut or drill a 2" diameter hole at the area
marked "M power supply cord hole" on the
upper cabinet template. If the upper cabinet
is metal, you will need to cover the edge of the
hole with the power supply cord bushing
(supplied) to prevent damage to the cord
from the rough metal edge.
4
Cut out the venting areas (with the saber saw)
• Roof-venting: cut out the shaded area
marked L on the upper cabinet template.
• Wall-venting: cut out the shaded area
marked F on the rear wall template.
• Room-venting: go to Step 5: Install the
Mounting Plate.
5
Complete whichever venting system you have
chosen. Use caulking compound to seal the
exterior wall or roof opening around the wall
cap or roof cap.
Advertisement
