Table of Contents
Advertisement
OPERATIONS
COPYING TAPES
When two decks are used, you can record the sounds from one deck
onto the other.
Application examples:
®To make a tape copy with contents identical to the original tape.
® To edit a recording of an FM broadcast in order to cut out unwanted
commercials,
recording only of desired
material onto another
tape.
When using two cassette decks
1. Load tapes for playback (pre-recorded tape) and
recording
(blank
tape)
into
the
respective
cassette decks.
2. Select the copying direction with input selector
buttons and TAPE 2 MONITOR button.
@ When copying from the cassette deck of TAPE 1/DAT terminals
to the cassette deck of the TAPE 2/MONITOR (ADPT) terminals:
Set the Input selector button to TAPE
1/DAT
and TAPE
2
MONITOR button to OFF.
® When copying from the cassette deck of the TAPE 2/MONITOR
(ADPT) terminals to the cassette deck of TAPE 1/DAT terminals:
Set the TAPE 2 MONITOR button to ON and the Input selector to
a position other then TAPE 1/DAT.
Operate the cassette decks to begin copying.
Set the cassette deck with the pre-recorded tape to the playback
mode. Set the cassette deck with the blank tape to the recording
mode.
sd
TO USE THE COMPONENT CONNECTED TO THE TAPE 2 MONITOR (ADPT) TERMINALS
[For an adaptor component]
By connecting a graphic equalizer, source sounds (from records,
tapes, AM/FM broadcasts, etc.) can be heard with added sound and
tone compensation.
Sounds compensated via the adaptor component can be recorded
(TAPE 1 REC terminals).
1. Set the TAPE 2 MONITOR button to ON.
2. Play back the source.
3. Operate the adaptor component.
[For a cassette deck]
A cassette deck connected here can be operated in the same way
{recording
and playback)
as a deck connected
to the TAPE
2/
MONITOR (ADPT) terminals.
Also, if two decks are used, you can copy tapes from one deck onto
the other (see the section "COPYING TAPES")
1. Set the TAPE 2 MONITOR button to ON.
2. Operate the cassette deck to perform playback
{or recording).
NOTE:
© The source selected with the input Selector is backed up for a few
days even when the Power switch is set to off or the power cord is
unplugged.
After this period, the CD is automatically selected when the power
fs supplied.
® Be sure to perform this operation with the adaptor component
power switch in the on position.
Even when not using the adaptor
component,
its power switch must be left an. If the adaptor
component is switched off, ne sound will be produced, or the
playback sound wilf be distorted.
8
<ARE1316>
En
Advertisement
Table of Contents
