Table of Contents
Advertisement
14
3. Pull out just enough film leader
to reach the take-up spool. Insert
the
en~
of
the
film into a slot on
the left side of the take-up spool,
making sure that a hole in the film
is lined up with the tooth on the
take-up spool
.
The sprocket teeth
should be engaged with holes at the
bottom of the fi lm.
4. With the film held against the
sprocket by your left hand, slowly
operate the film:advance lever until
the film is wound firmly around the
take-up spool, the sprocket teeth
are engaged with holes on both
edges of the film, and the slack in
the film is taken
up.
If the f
i lm-
advance lever stops at the end of a
full stroke during this
procedure,
release the shutter and continue
(main switch must be at on)
.
5. After making sure that the film
is taut, close the camera bac
k
by
pressing it until it locks shut with a
click
.
A red "S" should now appear
opposite the index in the
frame
counter.
Advertisement
Table of Contents
