Table of Contents
Advertisement
Setting the stereo amplifier
;
.
When
the Model A-1250S is connected
to. your amplifier
BME rAST
PAUSE
PLAY
(refer to page 7) to playback tapes, fully retard the stereo
ia
yas
amplifier volume control and preset the switches as below:
—@
POWER
Mode*
selector: To STEREO
(or to LEFT or RIGHT for
mono playback)
Tape monitor* switch: To TAPE
* These designations apply to TEAC amplifiers. Read the
Operating Manual
of your amplifier or inquire of your
dealer if it is of other manufacture.
NOTE 1 — For playback of mono
tape, switch to the
LEFT channel for track | (1st playback) and
4 (2nd playback), and the RIGHT Channel
for
track
3 (3rd
playback)
and
2 (4th
playback).
NOTE 2 — For setting the output level, adjust the stereo
amplifier volume control.
2
1 Set TAPE SPEED knob to desired tape speed.
2 Depress the POWER switch.
Tape speed:
Set to "H" (7% ips) or "L" (3% ips), to match
FAST
PAUSE
PLAY
the speed at which the tape was recorded.
_
4
oe
i.)
At playback of a high level recorded tape, adjust VOLUM.
cowe
control so as not to scale out the level meter pointers.
3. Thread tape on the deck.
4. Set Tape Mode
Lever to PLAY
and then depress the
c= button. The tape will then be transported from left to
right at the previously set speed. Once the C=- button is
the button is released. Depressing the <<
button will
cause the tape to be played back from right to left.
RECORD
1
5 Depress the STOP button and the tape will stop traveling.
1 Ser MONO
area
TALE
6 Set the Tape Mode Lever to FAST, depress the <>- button
and the tape will be wound at high speed (fast forward).
OUTPUT
7 Depressing the <2
button will fast rewind the tape.
(in the above operation, always depress the STOP button
before
reversing direction
of tape travel or tape may
2 Adjust playback level control (OUTPUT)
knobs (inner
break).
for L; outer for R) to the desired level.
Advertisement
Table of Contents
