Table of Contents
Advertisement
en Operating the appliance
Note that with the settings ˜:‹‚
Note:
and ˜:‹ƒ, the interior light 1" is
switched off. To activate the interior
lighting, press the ON/OFF switch (.
If the door is open for longer than
60 minutes, the light will switch off
automatically.
Here is how to change the setting:
Switch on the ON/OFF switch (.
1.
Hold down the programme button
2.
# and then repeatedly press the
START button P until •:‹...
appears in the display window.
Release both buttons.
3.
The LED of the # button flashes
and the digital display )" lights up
to show the value •:‹....
Press the programme button #
4.
repeatedly until the value ˜:‹...
appears in the display window )".
Press programme button 3.
5.
Each time the button is pressed, the
set value increases by one level;
when it reaches the value ˜:‹,ƒ the
display jumps back to ˜:‹‹.
Press START button P.
6.
The set value is saved.
* depending on the features of your
dishwasher
Switching off the appliance
Shortly after the end of the
programme:
Switch off ON/OFF switch (.
1.
Turn off water supply (does not
2.
apply to appliances with Aqua-Stop).
Remove the utensils when they have
3.
cooled down.
When the programme ends,
Note:
leave the appliance to cool down a
while before opening it. This will prevent
steam from escaping and causing
long-term damage to your built-in
furniture.
30
Interrupting the programme
Caution!
Expansion (overpressure) may cause
the appliance door to jump open and/or
water to escape! If the door was opened
on an appliance which has a hot water
connection or is heated, always leave
the door ajar for several minutes and
then close it.
Switch off ON/OFF switch (.
1.
The LEDs go out. The programme is
saved.
Switch on the ON/OFF switch (
2.
again to continue the programme.
Terminating the programme
(Reset)
Press the START button P and
1 .
T e r m i n a t i n g t h e p r o g r a m m e
hold it down for about 3 seconds.
The value ‹:‹‚ appears in the
display window )". The
programme sequence lasts about
1 minute. The value ‹:‹‹ appears in
the display window )".
Switch off ON/OFF switch (.
2.
Changing the programme
When the START button P has been
pressed, the programme cannot be
changed. The only way a programme
can be changed is by Cancel
programme (Reset).
Advertisement
Table of Contents
