Service Quick Guide
Service Quick Guide
AUTOTEST EOS DEA 700 - PLP 2 - Synchronous and BLAC* Motor
Models Covered:
TAll EOS dishwashers with electronics DEA 700 - PLP 2 - Synchronous and BLAC* Motor
Steps to complete before starting the autotest cycle:
1. close dispenser door
2. place a thermometer on drum (not essential for the test)
3. mount clear door - in this case, use a closure device to simulate electrical closure of door - (not es-
sential for the test)
4. complete the autotest entry sequence
Entry sequence:
BUILT-IN INSTALLATION
-
Switch on with on/off button
-
Press P
-
Press P
-
Switch off with on/off button
-
Press P
-
Press P
-
Switch on with on/off button
-
Close the door to start autotest
LCD-DISPLAY:
-
Switch on with on/off button
-
Switch off with on/off button
-
Press button (P) top arrow
-
Press button (P) top arrow
-
Switch on with on/off button
-
Press Start/Pause to start autotest
SELECTOR KNOB:
-
Switch on with on/off button
-
Switch off with on/off button
(start position different for 3 and 5)
-
Turn selector knob to program 5 position (prog. 3)
-
Turn selector knob to program 1 position
-
Turn selector knob to program 5 position (prog. 3)
-
Switch on with on/off button
-
Press Start/Pause to start autotest
Nota Bene: L N.B.: The procedures for running the autotest, setting water
*
hardness and rinse aid levels for DEA 700 PLP2 (visually distinguishable
thanks to the new DISPENSER and TUB) differ from before.
1/3
SQG_DW_23_EN
Indesit Company, Service Department
5