Control Guide - Panasonic SA-HE100 Operating Instructions Manual

RQT6208
Control guide
Memory button [MEMORY]
For presetting radio stations.
Help/reset button [-HELP, ~-RESET]
Press if an error message appears. A message offering a possible
solution scrolls across the display.
To reinitiate the unit's settings, press and hold until "RESET" appears.
Band select/FM mode select button
[-BAND, -FM MODE]
For switching between AM and FM.
If reception is poor in FM, press and hold until "MONO" appears to
switch to monaural mode.
Standby/on button [POWER, ©/]]
Press to switch the unit from on to standby mode or vice versa.
In standby mode, the unit is still consuming a small amount of power.
Speaker A/B select buttons [SPEAKERS, A, B]
Turning the speakers off automatically engages the STEREO mode
(when listening through headphones, for example).
If your speakers have an impedance under 6 9
Press and hold [A] or [B} until "LOW IMP" lights up on the display.
Note that when "LOW IMP" is on, SPEAKERS A and B cannot be used
at the same time.
Headphone jack [PHONES]
Plug type: 6.3 mm (1/4") stereo
Avoid listening for prolonged periods of time to prevent hearing
damage.
Turn the speakers off when using the headphones.
Tuning buttons [TUNING, V, A]
For tuning the radio and selecting preset stations.
Press and hold until the frequency starts scrolling to start automatic ae
tuning. Tuning stops when a station is found.
Tuning intervals: FM—0.2 MHz, AM-10 kHz
Preset channel button [PRESET]
Press to allow preset station selection with [TUNING, V, A].
NEO:6 mode select button [NEO:6]
Use when "NEO:6' lights in the ENHANCED SURROUND mode.
Dolby Pro Logic I mode select button
[DOLBY PRO LOGIC I]
Use when 'OO PRO LOGIC I" lights in the SURROUND mode.
Shows the input mode, radio frequency, and other general frequently (mp page 14).
information.
Speaker indicators [LOW IMP, SPEAKERS EN, [3]
LOW IMP: You have switched to LOW IMP because you have
connected speakers with an impedance under 6 Q.
SPEAKERS EJ: Sound is output from speakers connected to the
front A, surround, and center terminals.
SPEAKERS [E]: Sound is output only from speakers connected to emetoneerce SONG ALE
the front B terminals. | 3 ER STEREO
SPEAKERS Ø E]: Sound is output from speakers connected to
the front A and B terminals.
Radio indicators [TUNED, STEREO, MONO, M)
TUNED: A station is tuned.
MONO: You have switched to monaural mode with [-BAND, -FM
MODE] to improve reception. aek
STEREO: A stereo FM broadcast is tuned. ame indicator
M: Lights during presetting.
Lights when the A/D attenuator is
working.
Ki MA MA A NTA i ATi NERY Ce as
VN WM N EOE ZN ZN VM Mp
Enhanced surround mode
select button
[ENHANCED SURROUND]
DSP sound mode selector
[DSP SOUND MODE]
For selecting "STEREO",
"SURROUND" or "SFC".
Input overload indicator [OVER]
; Lights when input exceeds rated values.
General display Turn the A/D attenuator on if this occurs
or PCM sampling frequency
r-SOUND MODE— FIX [IPAO LOGIC E
STEREO SURROUND PCM NEO:
SFC Em ES OO DIGITAL
DSP sound mode
indicators
[SOUND MODE, STEREO,
SURROUND, SFC,
ENHANCED]
Show the current DSP sound mode.