1. Manuals
  2. Brands
  3. Salus Manuals
  4. Plumbing Product
  5. Karlstad II
  6. Owner's manual

Salus Karlstad II Owner's Manual

Red cedar barrel sauna with clear acrylic rear wall 4 person model
Hide thumbs
Table of Contents

Advertisement

Quick Links

Download this manual
FOR TRADITIONAL MODEL SAUNAS
REQUIRES 120VAC 15 AMP CIRCUIT
(FOR THE LIGHTING)
Red Cedar Barrel Sauna
With Clear Acrylic Rear Wall
Karlstad II
4 Person Model
OWNER'S MANUAL
Carefully and thoroughly read this Owner's Manual before
using/operating the sauna. We recommend keeping this Owner's
Manual for regular review and future reference. Follow your local
codes and ordinances. The heater must be installed by a
certified licensed electrician per the manufacturer's manual. The
heater must be installed per the electrical code in your area with
reference to the breaker and wire sizes. Models are subject to
change.

Advertisement

Table of Contents
loading

Related Manuals for Salus Karlstad II

Summary of Contents for Salus Karlstad II

  • Page 1 REQUIRES 120VAC 15 AMP CIRCUIT (FOR THE LIGHTING) Red Cedar Barrel Sauna With Clear Acrylic Rear Wall Karlstad II 4 Person Model OWNER’S MANUAL Carefully and thoroughly read this Owner’s Manual before using/operating the sauna. We recommend keeping this Owner’s Manual for regular review and future reference.
  • Page 2 Thank you for your purchase. As you remove the parts from the boxes, be sure to examine them for damages. If your unit has any damages or missing parts, please contact Golden Designs Inc. See the Warranty section for more information. A Certified Licensed Electrician will be needed to install the electrical wiring.
  • Page 3 WARNING! Do not place anything combustible close to heater, above the heater, and on both sides of the heater. This includes but not limited to towels, lights, robe hooks, accessories, etc. Nothing should be on the same wall as your heater that is combustible.
  • Page 4 9. Allow 30 seconds between turning the control system “On” and “Off”. By allowing 30 seconds between powering the control system “On” and “Off” will prolong the life of the unit. 10. Confirm that you adhere to the correct power requirements of the control system. Connecting the control system to other than the required voltage can damage the control system and possibly cause serious injury.
  • Page 5 24. Pregnant women should never use the sauna. Women should also not use the sauna during their menstrual cycle. 25. If you have any medical condition, you must consult with your medical doctor before using the sauna. 26. Be cautious not to over extend yourself after an intense exercise workout by using the sauna.

  • Page 6: Table Of Contents

    READ ALL INSTRUCTIONS THOROUGHLY BEFORE ASSEMBLY. TABLE OF CONTENTS Components Basic Dimensions Assembly Instructions Using the Barrel Sauna Tips for Using Your Sauna Safety Instructions Safeguards for Your Sauna Troubleshooting Warranty Warranty Card WARNING: Visually inspect all parts before assembly to make sure there are no damages.

  • Page 7: Components

    Components Karlstad Barrel Sauna *The above assembly diagram is for a quick reference visual guide only. All sauna models may not be shown. Parts and accessories do vary and are subject to change.
  • Page 8 Karlstad Barrel Sauna - continued *The above assembly diagram is for a quick reference visual guide only. All sauna models may not be shown. Parts and accessories do vary and are subject to change.
  • Page 9 Karlstad Barrel Sauna - continued *The above assembly diagram is for a quick reference visual guide only. All sauna models may not be shown. Parts and accessories do vary and are subject to change.
  • Page 10 Each Barrel Sauna will need between 66-68 staves plus 1 set of the staves (narrow) for assembly. You will end up with some extra staves (wide) and some extra staves (narrow). The rain cover is an optional accessory. Stave (wide) Stave (narrow set) What’s Needed: 3 Adults...

  • Page 11: Basic Dimensions

    Karlstad Barrel Sauna Basic Dimensions 4-Person Model Karlstad...

  • Page 12: Assembly Instructions

    Assembly Instructions 1. Place Bottom Support Cradles Place the bottom support cradles at their desired locations. See figure 1. Determine where the front and rear cradles will be positioned. The Karlstad model will have (3) support cradles. See figure 1a. The end support cradles will have a sticker indicating where the first stave will screw to the cradle.
  • Page 13 17” 17” 3.7” 72” figure 2 M5*50 figure 2a 3. Place Staves On Support Cradles Align the two ends of the staves. Carefully and accurately place them into the clamping staves. Use the leveler to make sure that each stave is placed level and straight.
  • Page 14 rubber mallet. Keep the staves snug and tight. The two staves with the pre-drilled holes will be the 7 staves (not counting the first installed stave) on the right and left. These two staves will need to be screwed down to the support cradles. Use the provided M5*50 screws to attached these staves to the support cradles.
  • Page 15 6. Continuing to Install Bottom Half of Acrylic Rear Panel You will need to locate the two wood planks that are used to connect the bottom and top acrylic rear wall sections. Use the provided screws to attach the two horizontal wood planks to each other (one on the interior and one on the exterior) through the acrylic rear wall lower section.
  • Page 16 figure 7 figure 7a 8. Install the Staves Continue to install and align the two ends of the staves onto the front wall panel and acrylic rear wall working your way upward. Carefully and accurately place them onto the front wall panel and acrylic rear wall. Use the leveler and mallet to make sure that each stave is placed level and straight.
  • Page 17 Use stainless steel nails at every other stave figure 8 9. Install Staves After reaching the 21 stave on the right side (when standing and facing the front door of the barrel sauna), you can stop on the right side and continue to install the staves from the left side until you have almost reached the right side.
  • Page 18 17MM Wrench figure 10 Attention: The joint position of the stainless steel band should be near the top and to the inside of the support cradles. Be sure to inspect the tightness of the stainless steel bands every 4-6 months to minimize small gaps. If the stainless steel bands become loose, use the 17mm wrench to tighten.
  • Page 19 figure 11a figure 11b 12. Install Short Bench Front Wood Plank, Bench Support Wood, and Short Bench Locate the short bench front wood plank, the bench support wood, and the bench. First, use the provide screws and mount the short bench front wood plank to the short bench supports.
  • Page 20 figure 12a 13. Install Wood Cover for Right Side Light Wire and Short Backrest with Accent Light Locate the wood cover for right side light wire and short backrest with accent light. Install the wood cover for right side light wire with the provided screws as seen in figure 13. Next, install the short backrest with accent light using the provided screws.
  • Page 21 figure 13c figure 13d figure 13e figure 13f The cord for the lights will need to be connected to a 120V 15AMP outlet. See figure 13g figure 13g 14. Install Stove Guard The heater guard will be installed on the right side of the interior front wall panel. First, located the parts of the stove guard.
  • Page 22 figure 14 figure 14a figure 14b 18. Install Roof Rain Cover (Optional) You have the option of installing the barrel sauna under a covered structure or out in the open. If you install the barrel sauna under a covered structure where it will not be affected by the weather elements, then it is optional to install the rain cover.
  • Page 23 provided (7) rain cover pushpins for each side to secure the rain cover at the front and rear of the sauna barrel. The remaining (8) rain cover pushpins are to be used to secure the horizontal edges for each side. See figure 15. figure 15 ASSEMBLY COMPLETE...

  • Page 24: Using The Barrel Sauna

    Using the Barrel Sauna 1. When entering the sauna, you can turn ON the light by pressing the “Light 2” button. Please note that the “Light 1” button has not function on this model barrel sauna. See figure 17. 2. Set the stove to the desired temperature, usually between 150 F - 180 F.

  • Page 25: Tips For Using Your Sauna

    Tips for using Your Sauna 1) If you take a hot/warm shower or bath before using your sauna, you may perspire more and experience more comfort. 2) Drink water prior to, during, and after your sauna session to replenish body fluids. 3) The ventilation vent is installed on the sauna and should never be obstructed.
  • Page 26 5.) Pregnant or possibly pregnant women should contact their physician prior to using the sauna. Excessive temperature has a high potential for causing fetal damage during pregnancy. 6.) Hyperthermia Danger: the normal body temperature can't rise above 39°C (103°F). Symptoms of excessive hyperthermia include dizziness, lethargy, drowsiness, and fainting.

  • Page 27: Safeguards For Your Sauna

    attempts will void the manufacturer’s warranty. 19) Please make sure the supplied power meets the specifications required. Failure to meet the requirements may cause safety risks. 20) Do not attempt to touch any electrical parts or make repairs on your own when using the sauna.

  • Page 28: Troubleshooting

    note that the heater must be OFF and covered when cleaning the interior of the sauna so not to damage any of the components of the heater, especially if you hose down the interior of the barrel sauna. 8. Check the stainless steel bands from time-to-time as they may need to be tightened due to the wood swelling and contracting.

  • Page 29: Warranty

    Limited Lifetime Warranty *Limited Lifetime Warranty: Golden Designs, Inc. warranties the sauna room against defects in material and workmanship for the life of the product from the original date of purchase. The sauna is for indoor use or outdoor use depending on the model. When placed outdoors, a water proof cover or the sauna shingle roof may be installed to cover the sauna room for protection.
  • Page 30 Customer Service For customer service, contact your authorized dealer. If you need additional information or assistance, please email Salus Saunas at service@salussaunas.com or call (888)287-0111. *Limited Lifetime Warranty of Sauna Products is 7 years on wood structure (when properly maintained), control panel, and applicable control panel harnesses and lights from the date of purchase.

  • Page 31: Warranty Card

    WARRANTY CARD Congratulations on your purchase from Golden Designs, Inc. Please take the time to complete the following Warranty Card and mail it back to: Golden Designs, Inc. 3550 Jurupa Street, Unit B Ontario, CA 91761 Please include a copy of your sales receipt showing date of purchase as this will serve as proof of purchase.

Table of Contents