Mitsubishi Electric Mr. Slim PUZ-M200YKA2.UK Service Manual page 111

Pattern 2
4. Toggle through the pages with the F3 or F4 button.
5. Select the mode number with the F1 or F2 button, and then press the [
button.
6. Select the setting number with the F1 or F2 button.
Setting range for modes 1 through 28: 1 through 3
Setting range for modes 31 through 66: 1 through 15
7. When the settings are completed, press the [
data from the remote controller to the indoor units.
8. When the transmission is successfully completed, the screen will return to the
Function setting screen.
Note:
• Make the function settings shown in Table 1 on Mr. SLIM units as necessary.
• Refer to the Instructions Book when it is necessary to set the settings for
CITY MULTI units.
• Table 1 summarizes the setting options for each mode number. Refer to the
indoor unit Installation
Manual for the detailed information about initial settings, mode numbers, and
setting numbers for the indoor units.
• Be sure to write down the settings for all functions if any of the initial settings
has been changed after the completion of installation work.
OCH775B
] button to send the setting
111
Function setting
Ref. address
Mode 1
1
Mode 2
1
Mode 3
1
]
Mode 4
1
Save:
Cursor
Function setting
Ref. address
Mode 1
1
Mode 2
1
Mode 3
1
Mode 4
1
Request:
Value
F1 F2
Grp. (1/8)
Page
Grp. (1/8)
F3 F4