Table of Contents
Advertisement
828
8h SO
CASSETTE RECORDER
GENERAL INFORMATION
[Recording from the CD player — CD synchro start
1 Select the CD by pressing the CD-TAPE-TUNER button
several times until 8] appears on the display.
2 Insert a CD and, if desired, program track numbers.
3 Press STOP-OPEN m
to open the cassette compartment,
4 Insert a blank cassette with the open side facing the front.
5 Close the cassette compartment by pushing it down.
6 Press RECORD @ to start recording.
~» Playing of the CD or program starts automatically. It is not
necessary to start the CD player separately.
7 For brief interruptions, press PAUSE I. To resume recording,
press the PAUSE If key again.
8 Jo stop recording, press STOP-OPEN mt A.
Notes: the recording can be started from different positions:
— if the CD player is in the Pause mode, recording will start
from this very position (use SEARCH i«« or p>);
— if the CD player is in the Stop mode, recording will start
from the beginning of the CD or program.
(Selecting and preparing the source}
RADIO: Select the radio by pressing the CD-TAPE-TUNER button
several times until
appears on the display.
MICROPHONE: Select the tape by pressing the
CD-TAPE-TUNER button several times until
appears on the
display. Connect a microphone with a 3.5 mm plug to the MIC
socket and set the VOLUME control to zero (monitoring during
microphone recording is not possible).
= ©
Press STOP-OPEN mi & to open the cassette compartment.
wo
NS
Insert an unprotected blank cassette with the open side facing
the front.
4 Press RECORD @ to start recording.
5 For brief interruptions press PAUSE I. To resume recording press
the PAUSE 11 key again.
6 To stop recording, press STOP-OPEN mm A.
Note: When recording from the radio or a CD, you can connect a
microphone and mix the sounds. Otherwise, be sure there is no
microphone connected that could disturb your recording.
(General maintenance
Do not expose the set, batteries, CDs or tapes to humidity,
rain, sand or excessive heat (caused by heating equipment or direct
sunlight).
The mechanical parts of the set contain self-lubricating bearings
and must not be oiled or lubricated!
You can clean the set with a soft, slightly dampened chamois cloth.
Do not use any cleaning agents as they may have a corrosive
effect.
To ensure proper recording and playback quality, clean the parts
after approx. 50 hours of operation. Use a cotton bud
slightly moistened with alcohol or a special head-cleaner fluid.
Press PLAY > and clean the rubber pressure rollers ©.
Press PAUSE tt and clean the capstans (8) and the heads @).
Note: Cleaning of the heads @ can also be done by playing a
cleaning tape once.
ED pl
D
handling
The lens may cloud over when the set is suddenly moved from
cold to warm surroundings. Playing a CD is not possible at such
times. Leave the CD player in a warm environment until the
moisture evaporates.
To take the CD out of its box easily, press the centre spindle while
lifting the CD.
Always pick up the CD by the edge and put it back in its box
after use.
To clean the CD, wipe it in a straight line from the center toward
the edge using a soft, lint-free cloth. A cleaning agent may damage
the disc!
Never write on a CD or attach a sticker to it.
This set complies with the radio interference requirements of the
European Community
ASN
YO
NOILONY.LSNI
Ou}
Jo Jdueoxe
joug
Ge
Advertisement
Table of Contents
