Viking Designer DMOC205SS Installation Instructions
Professional series convection microwave built-in trim kit
Hide thumbs
Also See for Designer DMOC205SS:
- Service manual (48 pages) ,
- Specification sheet (4 pages) ,
- Installation use and care manual (128 pages)
Advertisement
Quick Links
Download this manual
See also:
Service Manual
INSTALLATION
INSTRUCTIONS
PROFESSIONAL SERIES
CONVECTION MICROWAVE BUILT-IN TRIM KIT
Retain for Future Reference
IMPORTANT - PLEASE READ AND FOLLOW
• Before beginning, please read these instructions completely and carefully.
• Be sure to DISCONNECT THE PLUG of the microwave oven from the electrical outlet before installing the built-in trim kit.
Remove the turntable from the oven cavity.
• Because the kit includes metal parts, caution should be used in handling and installation to avoid the possibility of injury.
• Do not remove permanently affixed labels, warnings, or plates from the product. This may void the warranty.
• Please observe all local and national codes and ordinances.
• The installer should leave these instructions with the consumer who should retain for local inspector's use and for future
reference.
THIS BUILT-IN TRIM KIT IS DESIGNED FOR USE ONLY WITH VIKING CONVECTION MICROWAVE OVENS SPECIFY-
ING BUILT-IN TRIM KIT VMTK275/276, VMTK305/306 OR VMTK365/366 ON THE RATING LABEL ON THE BOTTOM
FACE PLATE OF THE OVEN CAVITY.
IF YOUR LOWER CONVENTIONAL OVEN IS NOT LISTED IN THE USE AND CARE MANUAL OF THE MICROWAVE
OVEN, THEN DO NOT INSTALL THE MICROWAVE OVEN ABOVE IT OR IN ANY AREA WHERE HEAT AND STEAM
ARE GENERATED; FOR EXAMPLE, NEXT TO OR ABOVE A CONVENTIONAL RANGE.
PARTS INCLUDED IN THE VMTK KITS
1) Front Frame Assembly
QTY 1
6) Duct A (1)
QTY 1
2) Bottom Duct Assembly
QTY 1
7) Duct A (2)
QTY 1
3) Screw A (1/2" length)
4) Screw B (1-3/4" length)
QTY 10
8) Duct A (3)
9) Duct B
QTY 1
VIKING RANGE CORPORATION
111 Front Street
Greenwood, Mississippi 38930 USA
(662) 455-1200
5) Screw C (1-3/16" length)
QTY 4
10) Duct C
QTY 1
QTY 2
QTY 1
Advertisement
Related Manuals for Viking Designer DMOC205SS
Summary of Contents for Viking Designer DMOC205SS
- Page 1 IF YOUR LOWER CONVENTIONAL OVEN IS NOT LISTED IN THE USE AND CARE MANUAL OF THE MICROWAVE OVEN, THEN DO NOT INSTALL THE MICROWAVE OVEN ABOVE IT OR IN ANY AREA WHERE HEAT AND STEAM ARE GENERATED; FOR EXAMPLE, NEXT TO OR ABOVE A CONVENTIONAL RANGE.
-
Page 2: Cabinet Or Wall Cutout
BASIC SPECIFICATIONS Microwave Oven Overall Width 4-5/8” Overall Height from 14-7/8” Bottom Overall Depth from 19” Rear Oven Interior Width Height Depth Overall Cutout Width Cutout Height Cutout Depth Electrical 10VAC/60 Hz (UL) Requirements 117VAC/60 Hz (CSA) Max. Amp Usage 1.55 KW 1.5 KW Approx. Shipping Wt. 60 lbs. CABINET OR WALL CUTOUT Provide an opening in the wall or cabinet as indicated in illustration 1. The depth should be a minimum of 0-1/8" (51.1 cm). The floor of the opening should be constructed of plywood strong enough to support the weight of the oven (about 100 lbs.) and should be level for proper operation of the oven . - Page 3 EXHAUST DUCT ASSEMBLY CONT. . Position DUCT (A)-1 on the top of the oven inserting edge of DUCT (BC) assembly into hole lip of DUCT (A)-1. Tighten two SCREWS (A), securing DUCT (A)-1 to DUCT (BC) assembly. See illustration 3. 3. Position DUCT (A)- on the top of the oven and insert it into the hold lip of DUCT (A)-1. Secure DUCT (A)- to DUCT (A)-1 using two SCREWS (A) provided. See illustration 4. 4. Position DUCT (A)-3 on top of the oven and insert it into DUCT (A)-. Secure DUCT (A)-3 using three screws (A) provided. See illustration 5. 5. Place the Bottom Duct in the opening. When the Bottom Duct Assembly is in the opening correctly, the flanges will be tightly against the lower edge of the opening. See Illustration 6. 6. Secure the Bottom Duct Assembly with the two (1-3/16”) screws C. IMPORTANT: Secure screws in outer hole. Illustration 3 DUCT A-1 SCREW A DUCT BC Illustration 5 SCREW A SCREW A Illustration 4 SCREW A SCREW A Illustration 6 DUCT A-3 FLANGES SCREW A DUCT A-2 SCREW DETAIL A...
-
Page 4: Cabinet Installation
Illustration 8 OVER OVEN INSTALLATION Illustration 10 2" (5.1 cm) For 27" W and 30" W lower oven 4" (10.2 cm) For 36" W lower oven Viking Range Corporation Specifications subject to change without notice. FOOT BOTTOM DUCT ASSEMBLY DUCT RECESS MICROWAVE CUTOUT LOWER OVEN CUTOUT (PS0506VR)