Element ELCHS262 User Manual page 23

Hide thumbs Also See for ELCHS262:
Table of Contents

Advertisement

Appendix
Before
calling a service technician,
please check the following
table for a possible
cause of the problem
and some
solutions.
Customer
important
notice:
If the TV functions
cannot
be operated,
unplug the AC cord from AC power
source,
wait at least 1 minute,
then re°plug
AC cord. This will reset the TV settings
and should
restore TV to
normal
operation.
Symptoms
TV will not turn on
No picture,
no sound
No sound,
picture
OK
Possible
Solutions
u
=
m
m
=
m
m
=
B
u
=
=
u
=
m
Poor sound,
picture
OK
Poor picture,
sound
OK
Unable
to select
a certain
channel
B
Poor colour
or no colour
=
m
The
remote
control
does
not
operate
,
B
m
Disorder
display
at power
or
m
m
Remote
control
programming
Hake sure the power cord is plugged in, then press Power
(Standby),
The remote control batteries
may be dead. Replace the batteries.
Unplug the VGAwire
and plug the power wire again.
Check if you have set the timer off.
Check the antenna/cable
connections,
Press [Display]
to see if you have selected the right signal source.
The sound may be muted. Press [VOL+ ] on the remote control.
The station may have broadcast difficulties,
Try another channel,
Check the speakers cable connections.
Check if earphones are plugged into unit.
The station may have broadcast difficulties.
Try another channel
Check the speakers cable connections.
Check the antenna connections.
The station may have broadcast difficulties.
Try another channel.
Adjust the picture from the menu.
The channel may be skipped. Choose this channel by directly selecting
the buttons from the remote control.
The station may have broadcast difficulties,
Try another channel,
Adjust Saturation
in the Video settings menu.
There may be an obstruction
between the remote control and the
remote control sensor.
The batteries
may be installed
with a wrong polarity.
The remote control batteries
may be dead, Replace the batteries.
This may be caused because of a very short interval between POWER
OFF and ON.
Unplug the power and restart.
Cable and Satellite
content
providers
control the remote codes,
and we apologize
for any confusion
during the remote programming.
Please try the following
codes 10019, 0178, 10178, 0030, 10030,
0835, 10835, or for Dish Network
try 627,659
or 505. For Fios
TV (Verizon),
try the code 3264. These codes may not work on some
universal
remotes.
If there is another
code listed for Element
Electronics
in your universal
remote control guide, please
try that
code. Refer to the Remote
Control Guide under your TV's model
number for more information.
You may also visit us at www.etementetectronics.com
to address
any product
use and performance
questions
you may have
22

Advertisement

Table of Contents
loading

Table of Contents