Advertisement
PC/HDMIAudio
The PC and HDMI inputs share the same set of analog audio
inputs. If you have both a PC and an HDM[/DVI
device
connected
to the monitor
(and the HDM[/DVI
device requires
analog audio output), use the PC/HDMI
Audio
setting to
specify which audio (PC or HDMI/DVI)
will be output from
the monitor's
speakers
(Ir_ _" pages 14-15).
To set the PC/HDMI
Audio:
SS
MENU
Press
O and open tile Set Up menu.
2
Highlight AV Connection and press @.
3
Press • or • to select PC/HDMI
Audio,
and then press
• or•
to select PC or HDMI.
PC: Mutes the sound from the HDMI device, and outputs
the sound of the PC.
HDMI: Mutes the sound fl'om your PC, and outputs
the
sound of the HDM[ device.
Note:
• The PC/HDMI Audio setting influences the HDMI
Audio
setting, if the PC/HDMI Audio setting is set to
HDMI, the HDMI Audio setting changes to Auto. if the
PC/HDMI Audio
setting is set to PC, the HDMI Audio
setting changes to Digital and will be grayed out.
° The PC IN and HDMI IN terminals share the audio
inputs labeled PC/HDMI (,4UDIO) on the monitor's back
panel.
Settingthe sleeptimer
You can set tile sleep timer to turn off tile monitor ariel a set
length of time (maximum of 12h50m).
To set the sleep
timer:
SS
SLfEEP
Pre.;:
o
on the remote control to set the length of time until
the monitor
turns oft: Repeatedly
press s_Ep to increase
the
time in 10-minute
increments,
up to 12h50m (12 hours and 50
minutes).
To cancel
the sleep
timer:
SS
SLfEEP
"
"
Pre.;:
o
untd it is set to 00h00m.
To set the sleep
timer
using
the on-screen
menus:
SS
MENU
Pre.;s
o
and open tile "rimer
menu.
2
Press • or•
to highlight
Sleep
Timer.
3
Press the Number
buttons
(0-9) or • or • to enter the
length of time until the monitor
turns off automatically.
EXIT
Press
o to start the timer.
Note:
• When a power failure occurs, the sleep timer setting may be
cleared.
• To display the amount of time remaining on the sleep timer,
press _c_L
38
Advertisement
