Acer Aspire 1430 Series Service Manual page 28

The Set Supervisor Password or Set User Password box opens.
2. Type the current password, then press
Enter
3. Press
4. You will be prompted to confirm the password removal.
Enter
5. Press .
F10
6. Press to save the password and close the Setup Utility or you can proceed to setting a user
password.
Resetting a password
If you have forgotten the user password, the computer will continue to function normally but you will have
limited access to the Setup utility.
If you have enabled the Password on Boot field and you forget the supervisor password, you will not be able to
boot up the computer. The same thing applies if you forget the HDD password.
To clear a lost BIOS password (user or supervisor password) you need to short the clear password hardware
gap located on the system board. Go to
To regain access to your computer if you lose the HDD password, you need to generate a master password
and unlock your hard drive. Go to
Boot
Use the Boot menu to set the preferred drive sequence in which the Setup utility attempts to boot the operating
system.
To set boot drive sequence:
↑ ↓
1. Press or
F5
2. Press or
F10
3. Press to save the changes you made and close the Setup utility.
Maintenance and Service Guide,Service Manual,Motherboard Schematics for Laptop/notebook http://faqp.ru/
20
HTTP://FAQP.RU/ - хемы, сервис м ну лы, инструкции по р зборке ноутбук
twice without entering anything in the new and confirm password fields.
page 21
page 22
to highlight a bootable device.
F6
to move the selected device up or down the boot sequence.
Enter
.
for instructions.
for instructions.
Chapter 2