Advertisement
Quick Links
Initiate Dialing from a Contact Closure
All of Viking's Hot-Line dialers, both exisiting and
discontinued, may be configured to dial when triggered by a
contact closure. This is ideal for applications where a piece
of equipment provides the closure, allowing the dialer to dial a
phone number or pager number for alarm notification.
Important: Different revisions of products may require different programming and/or setup.
Please read your serial label to find the proper section.
This document must be used in
!
combination with the product's Technical
Practice.
A. Converting the K-1900-5 to Contact Closure Dialing
Important: Electronic components are sensitive to static electricity. Personnel and the work area
should be grounded before handling.
1. Remove the cover of the K-1900-5 with your hands.
2. Locate JP1.
Note: There are (2) two pin headers on the circuit board. Use the diagram (right) to find JP1.
3. Short the two pins on JP1 together. Wrapping a bare telephone wire around both pins is suggested.
4. When finished, replace the cover.
Important: Be sure whatever is used to short the jumper is not touching any other components.
B. Installation
Note: The K-1900-5 will drop the line as
soon as it is done dialing, so it is important
to add several pauses to the end of the
dialing string to allow time for the call to go
through.
If the contact or switch is
continuous, the K-1900-5 will drop the line
when closure is released.
Telecommunication Peripheral Products
Application Note
K-1900-4
K-1900-5
Various contact closures are
required depending on the
dialer.
http://www.VikingElectronics.com
Info@VikingElectronics.com
Sales...(715) 386-8861
Contact Closure or switch
(2 second minimum)
phone plug
Red/Green
Contact Closure
Dialing with Hot-Line
Dialers
October 8, 2003
K-1900-5
Model
Fax Back Document Number
K-1900-4
K-1900-5
K-2000-DVA
JP1
K-1900-5
VIKING
©
Programmable
Tone Dialer
MODEL: K-1900-5
Viking Electronics, Inc.
Hudson, WI 54016
Modular
315
317
303
C.O. line or analog
PABX/KSU station
RJ-11
Advertisement
Related Manuals for Viking K-1900-4
Summary of Contents for Viking K-1900-4
- Page 1 Telecommunication Peripheral Products Application Note Initiate Dialing from a Contact Closure All of Viking’s Hot-Line dialers, both exisiting and discontinued, may be configured to dial when triggered by a contact closure. This is ideal for applications where a piece of equipment provides the closure, allowing the dialer to dial a phone number or pager number for alarm notification.
- Page 2 Product Support Line...(715) 386-8666 Due to the dynamic nature of the product design, the information contained in this document is subject to change without notice. Viking Electronics, its affiliates and/or subsidiaries assume no responsibility for errors and/or omissions contained in this information. Revisions of this document or new editions of it may be issued to incorporate such changes.