Henny Penny LOV3 Quick Reference

Operation
Start-up
1. Turn main power switch on.
2. Verify basket rests and baskets are clean and in place.
3. Verify oil is filled to lower level indicator .
4. Fill vat if needed.
Menu > Oil & Filter > Fill Vat > Fill Vat from
Fill vat from
Drain Pan Bulk JIB Manual Fill
Express Filter
Express Filter
– Tap oil icon to access
Express Filter from
most menus.
Oil Filter %
• Tap Express Filter when prompted
14:28 01/03/2023
Previous Express Filter
• Select Filter as often as possible to
0
Skipped Express Filter
» Extend oil life
Express Filter
» Avoid unclogging the drain
– Reset oil filter percentage
» Keep product quality high
before you get busy by
» Avoid nuisance E-10 high limit errors
tapping Express Filter.
Replacing the JIB
When Check JIB displays:
1. Pull JIB out from under the fryer
2. Remove JIB tube from empty JIB
3. Open and remove seal from new JIB
4. Insert JIB tube into new JIB
5. Push JIB under fryer and close door
Energy Saving Mode
Set up Dual Language
• Swipe up to reveal the quick action dock then tap the ECO mode button.
Scan the QR code in the upper right corner to view videos of these procedures
and more.
LOV3 Quick Reference
WARNING! Burn Risk! Oil and surfaces of fryer and filter pan are hot.
Wear PPE when performing cleaning and maintenance procedures.
Before operating the fryer, read and understand the complete operation manual that is supplied
with the unit paying close attention to all safety messages.
Troubleshooting
(located on front of fryer
• Allow motor to cool for 20 minutes
• Press reset button
(The high limit switch
• Express filter the vat (clean all crumbs from vat)
• Allow oil to cool 20 minutes
• Reset high limit by opening the door below the vat and pressing the reset
switch
Note: There is a control reset switch next to the high limit reset E
WARNING!
Filter Motor Not Running
)
E-10 High Limit Reset
E is accessed by opening the corresponding door)
E
. Use this in the event of a frozen control.
Scan code to see
videos of these
procedures and more!
Maintenance
Daily Filter and Cleaning
1. Perform Daily Maintenance Filter on each vat
menu > oil & filter > daily maintenance filter
2. Remove and clean basket hanger , basket rests and
baskets .
3. Perform daily filter pan maintenance and install basket
hanger .
4. Clean exterior of fryer.
Filter Pan Maintenance
Throughout the day
Empty crumb basket as needed (G1.)
Once per day
1. Clean and dry filter pan.
2. Replace filter (G2).
3. Lubricate O-rings (G3).
Every 90 days
Replace O-rings x3 (G3).
175860 (10 pack)
Shutdown
1. To turn off a vat, swipe up to reveal the quick action dock then tap
the power button.
2. Turn main power switch to the off position to turn fryer off.
Set up Dual Language
As Needed Maintenance
• Test and replace oil based on restaurant guidelines
• Perform Deep Clean procedure after changing oil
• Tighten Element Guard every 90 days
Scan the QR code in the upper right corner to view videos of these
procedures and more.
FM08-926A