Table of Contents
Advertisement
2.3.7 МОТОВ
1.
2.
3.
4.
5.
6.
Remove the cabinet. (Refer to section 2.1.2)
Remove the evaporator. (Refer to section 2.2.1)
Remove the orifice. (Refer to section 2.2.1)
Remove the blower. (Refer to section 2.2.1)
Remove the fan. (Refer to section 2.2.2)
Remove the control box cover and disconnect 5 or
4 wires of motor housing. (Refer to section 2.1.3)
. Remove the 2 or 4 screws which fasten the motor
from the mount motor. (See Figure 15)
. Remove the motor.
. Re-install the components by referring to the
removal procedure, above.(See Figure 15)
2.4 REFRIGERATING CYCLE
CAUTION
Discharge the refrigerant system using a
Freon™ Recovery System.
If there is no valve to attach the recovery
system, install one (such as
a WATCO А-1)
before venting the Freon", Leave the valve in
place after servicing the system.
2.4.1 CONDENSER
1.
2.
3.
Remove the cabinet. (Refer to section 2.1.2)
Remove the 4 screws which fasten the
brace.(Refer to section 2.2.1)
Remove the 5 screws which fasten the condenser
and shroud.
. After discharging the refrigerant completely,
unbraze the interconnecting tube at the condenser
connections.
. Remove the condenser.
. Re-install the component by referring to notes.
(See Figure 16)
2.4.2 EVAPORATOR
—
5.
6.
. Remove the cabinet. (Refer to section 2.1.2)
. Remove the 2 screws which fasten the evaporator.
. Move the evaporator sideways carefully.
(Refer to section 2.2.1)
. After discharging the refrigerant completely,
unbraze the interconnecting tube at the evaporator
connections.
Remove the evaporator.
Re-install the component by referring to notes.
(See Figure 17)
Figure 15
Figure 16
Figure 17
Advertisement
Table of Contents
