Philips 55PFL5755 Service Manual page 8

There is no "Adaptive Backlight" item, "Auto/Low/Mid/High" "Backlight" "ADP low
control point" "ADP mid control point" "ADP high control point" are in the "feature"
page. There is only "Backlight" item instead of "Backlight Low" "Backlight Mid"
"Backlight High". It set the backlight value of current backlight mode.
3) ADC Calibration
Item
ADC Calibration
4) WD Alignment
Item Sub-item
WD Alignment Pic. Enhance
Source
Color
Temperature
R Gain
G Gain
B Gain
R Offset
G Offset
B Offset
Scaling
Brightness
Scaling Contrast
Scaling Saturation
Auto phase
Sub-item Value
Source HDMI,etc
Auto color Run
Status NONE
/ NOK
/ OK
/ ALL
R Gain
G Gain
B Gain
R Offset
G Offset
B Offset
Value
ON/OFF
HDMI,etc
Normal
/Warm/Cool
Run
Note
VGA\CMP\scart RGB require Calibration
Press "OK" key to run
NONE:No source has been calibrated
NOK:Current source hasn't been calibrated
OK: Current source has been calibrated
ALL:All sources have been calibrated
For fine tune ADC manually.
Note
Press "Right" key to switch off all of the
items in the feature submenu. This should
be done before white balance alignment. If
it's off, the way to switch it on is to reset
user/shop or set on the features in Feature
sub-item manually.
For balance source
HDMI,VGA,DTV,PAL,SECAM,NTSC,Scart
RGB,CPM, HDMI
The value of Warm and cool is the offset of
Normal mode.
R White balance
G White balance
B White balance
R Gray balance
G Gray balance
B Gray balance
Press "OK" key to adjust the signal to
avoid the ripple in CMP source, it is not
necessary.
8