Table of Contents
Advertisement
Connecting Your Tumir:
Connecting Your Stereo Record Player:
A stereo cartridge is essentially two cartridges in ome amil uses two ouput
connecting plugs. If yeu are using a low level maguetic cartridge phig one output
lead into
the LEFT LOW LEVEL INPUT locatel on the lower left rear of the
chassis, and the other plug into the RIGHT LOW LEVEL INPUT jack. Both
PHONO, TAPE switches located directly above the LOW LEVEL INPUT jacks
must be placed in the up or "PHONO" position.
Stereo crystal or ceramic cartridges may also be used with this amplifier.
They
must be plugged into the LEFT and RIGHT FHONO-HI jacks located on
the HIGH LEVEL INPUT strip on the rear panel. Plug the AC line cord of your
record player into one of the AC convenience outlets located on the rear panel
of the Model A-224 amplifier,
Connecting Your Stereo Tape Player:
A steresphonic tape deck utilizes two pliyback
heads. Each head has its
own output pug. Connect one
plug to the LEFT LOW LEVEL
INPUT jack
located on the lower rear of the Daan: and the other apn
ping to the RIGHT
LOW LEVEL INPUT jack. Place both PHONO/TAPE switches located directly
above the LOW LEVEL INPUT jacks down, in the "TAPE" position.
Since the Model A-224 has anly one pair of low level input receptacles. for
stereo use, cither a magnetic cartridge or a tape head may be plugged in, It
beth types of
program sources are desired, it is suggested a ceramic cartridge be
used instead of a magnetic type. The tape head can then be plugged inte the two
LOW LEVEL INPUT jacks and the ceramic cartridge can be plugged into the
two PHONO-HI jacks,
Connecting Your Stereo Tape Recorder:
Since most sterco tape recorders have their own preamplifiers, it is mot de-
sirable to plig the autput of the recorder into the LOW
LEVEL INPUT. This
might canse overloading
of the input stage. Connect one of the output plugs into
the TAPE-HI/AUX jack on the RIGHT HIGH LEVEL INPUT strip and the
other inte the TAPE-HI/AUX
jack on the LEFT
HIGH
LEVEL
INPUT strip.
Connecting Your Tape Recorder To Make A Recording:
Provision is made on your Model A-224 to permit the recording of any
pro-
gram material. Connect the left input of your stereo tape recorder to the ra-
ceptacle marked LEFT TAPE OUT on the rear panel and the right input of
your stereo tape recorder to the receptacle marked RIGHT TAPE OUT. To con-
nect a monaural tape recorder, connect its input to either LEFT or RIGHT
TAPE OUT receptacle, If the program source you desire to record is plugged
inte the left preamplifier channel, use the LEFT TAPE OUT jack, and if it is
plugged inte the right preamplifier channel, use the RIGHT TAPE OUT jack.
This will enable you to make a recording with the proper recording equalization
as determined by your recorder, while simultancously monitoring the program
with the proper tone control, contour and lowdness setting.
Advertisement
Table of Contents
