Sony SSM-Q177 Operating Instructions Manual page 7

1 INPUT select switch
Keep this switch released (ø CAMERA) to monitor the
signal from the CAMERA IN connector.
Depress this switch (Ø VCR) to monitor the signal from the
VCR IN connector.
2 H-HOLD (horizontal hold) control
When the picture has slanting horizontal bars, turn the H-
HOLD control in either direction until a stationary picture is
obtained.
3 V-HOLD (vertical hold) control
When the picture rolls up or down on the screen, turn the V-
HOLD control until a single stationary picture is obtained.
4 BRIGHT (brightness) control
Turn clockwise for a brighter picture and counterclockwise
for a darker picture.
5 CONTRAST control
Turn clockwise to increase picture contrast and
counterclockwise to decrease it.
6 POWER switch and indicator
To turn on the monitor, depress this switch. The green
indicator lights up.
To turn off the monitor, press the switch again.
7 AUTO SWITCHER / QUAD select button
Press this button to choose AUTO SWITCHER mode or
QUAD mode.
8 CHANNEL select button
If you have chosen AUTO SWITCHER mode above, the
screen shows pictures from each of the cameras, one at a
time in sequence starting from CH1, and repeats the
sequence over and over. To stop the sequence at a particular
channel, press the button for that channel, the sequence will
stop and the picture stays. To restart the sequence, press the
button again.
If you have chosen QUAD mode, the screen shows
4 channels at the same time. If you press a CHANNEL
button, the channel you have selected shows a FREEZE
picture.
9 SET UP (ENTER) button
Press this button to go to MAIN MENU display. To proceed
to SUB MENU or to select an item, press the same button.
7