Table of Contents
Advertisement
NOTE FOR THE REPLACING OF MEMORY IC
NOTES:
* Initial Data setting will not be possible if clock has been set. To reset clock, either unplug AC cord and allow
Table 1
1. Enter DATA SET mode by setting VOLUME to minimum.
2.
While holding down VOLUME button on front cabinet, press key 6 on remote control simultaneously.
3. ADDRESS and DATA should appear as FIG 1.
ADDRESS
DATA
[esse See oe
INIT
00
83
POWERON 0010
PLAY/REC
0003
Fig. 1
Press ENTER to select DATA. When DATA is selected, it will "blink".
Again, step through the DATA using SET + or - until required DATA value has been selected.
Pressing ENTER will take you back to ADDRESS for further selection if necessary.
Repeat steps 4 to 7 until all data has been checked.
When satisfied correct DATA has been entered, turn POWER off (return to STANDBY MODE) to finish DATA input.
he unit will now have the correct DATA for the new MEMORY IC.
>
4OONOM
C4-1
Advertisement
Table of Contents
