Installation; Connecting To A Power Supply; Connecting To Other Equipment - Arcam Alpha 7 Handbook

Section A
Installation
CONNECTING TO A POWER SUPPLY
WRONG PLUG ?
If the plug supplied with the tuner does not fit your power
supply, see the inside back cover of this handbook for guidelines on
changing a plug, or contact your dealer to obtain a suitable power
cord.
Check that your mains supply voltage agrees with the voltage
setting indicated on the rear panel of the 1) tuner.
If your mains supply voltage is different, consult your Arcam dealer or
Arcam Customer Support on 01223 203203.
PLUGGING IN
Push the plug (IEC line socket) of the cable supplied with the tuner
into the socket (POWER INLET) in the back of the tuner,
Make sure it is pushed in firmly
IEC LINE SOCKET
Push the plug on other end of the cable into your power supply
socket.
The tuner is double insulated and does not require an earth.
This is why there is no centre (Earth) pin in the socket (POWER
INLET)
CONNECTING TO OTHER EQUIPMENT
All the sockets carrying messages te other hi-fi equipment (output
channels) are colour coded for identification.
The use of high quality interconnect cables to and from other hi-fi
equipment is recommended to ensure the best sound quality (sonic
performance).
Interconnect cables are not supplied with these tuners.
The left channel sockets are marked L.
The right channel sockets are marked R.
CONNECTING YOUR TUNER TO YOUR AMPLIFIER
@ AUDIO OUTPUTS
There are two pairs of identical outputs provided. Connect
one of these to your amplifier's tuner input using a suitable
interconnect cable. Insert the red phono plug into the
socket labelled 'R' for Right and the other phono plug into
the socket labelled 'L for Left.
The second set of audio outputs can be used to connect to
a second amplifier set up for 'multi room' use or routed to
a tape recorder for 'off air' recording.