Advertisement
Step 8. After installing all SSDs, carefully flip the heatsink to the right.
Step 9. Carefully reinsert in the power supply cable of the cooling fan
that was removed in step 2.
Step 10. On the rear of the R1108A, refasten the 6 screws that were
removed in step 1.
Note:
Make sure the aluminum cover is properly aligned with the
HBA board (PCB), and that it makes full contact with the thermal
pad, before refastening it to the R1108A. If the cover is improperly
installed, the fan and thermal pad will be unable to sufficiently
cool the NVMe SSDs and HBA componentry, which may result in
damage to the SSDs or HBA hardware, performance loss,
unstable I/O, and the loss of data.
7
Advertisement
