Table of Contents
Advertisement
C. INSTALLATION OF THE UNIT
C.4.3 Wall Sleeve Installation Instructions (PDXWS)(Cont)
OPTIONAL SUBBASE
LEVELING SCREW
Figure C.4.3.2 (Panel Wall)
WOOD FRAME
OPTIONAL SUBBASE
LEVELING SCREW
Figure C.4.3.4 Frame and Brick Veneer
NOTE:
Follow all wall system manufacturer installation instructions. For sun rooms and modular buildings, adhere to their installation
instructions for supporting and sealing sleeve to their frames. All wall and window/wall installations must provide for proper drainage. In
applications where the drain holes on the PTAC wall sleeve are not exposed beyond the wall an internal drain system is recommended. It is
the installer's responsibility to ensure there is adequate drainage for the PTAC unit.
16
1/4" MIN
PROJECTION
STEEL
LINTEL
11" MIN.
WITH SUBBASE
CASE FLANGE
(BY OTHERS)
OPTIONAL SUBBASE
LEVELING SCREW
Figure C.4.3.3 Curtain Wall
CONCRETE LINTEL
RECEPTACLE
FINISHED FLOOR
Figure C.4.3.5 Block and Brick Veneer
1/4" MIN
WALL OR
PROJECTION
WINDOW
1/4" MIN
PROJECTION
STEEL
LINTEL
13-3/4" MIN.
WITHOUT SUBBASE
POWER SUPPLY CONDUIT
(SUPPLIED BY INSTALLER)
Advertisement
Table of Contents
