Receiving Broadcasts - Sony RDS EON STR-DE515 Operating Instructions Manual

12"
Receiver Operations
4 On the other remote, select the function that the
receiver's remote is to "learn" and hold down its
button until the LEARN indicator lights steadily.
5 Repeat Steps 3 and 4 to programme other buttons.
Note that each button can only "learn" one signal
from another remote.
6 Press LEARN.
After the LEARN indicator turns off, you can
control the other component with the
programmed buttons.
Kay When you programme the recording signal
While holding down the @ button on the receiver's
remote and press the record button on the other remote.
Cif you cannot successfully programme signals, check
the following:
¢ If the LEARN indicator does not light up at all, the
batteries are weak. Replace both batteries.
¢ If the LEARN indicator does not flash or light up in
Step 3 or 4, there is interference. Clear the signal as
described in "Clearing the programmed signal"
below and programme again from the beginning.
¢ The two remotes are placed too far apart. Make sure
they are only 5 cm (2 inches) apart.
If you don't proceed to the following steps within
about 1 minute during Steps 2 and 3, the remote
automatically exits learning mode. Start again from
Step 2.
¢ If the memory in the remote has become full, (If you
programme signals of Sony components, you can
store about 30 signals.) you can programme a new
signal on a previously programmed button, but the
new signal] will replace the previously programmed
one.
Notes
¢ You cannot turn on programmed components by pressing
a SYSTEM CONTROL/FUNCTION button. You have to
turn on the component's power switch.
¢ Do not programme remote signals of air conditioners or
other household appliances.
Clearing the programmed signal
To clear the programmed signals, do the following:
Hold down SYSTEM-OFF, VISUAL POWER and VOL-
keys together, LED will blink 3 times. This indicates
that the remote is initialize to factory-preset.
The button's functions are reset to the factory-preset.
ea FE ar eS
Receiving Broadcasts
This receiver lets you enter a station's frequency
directly by using the numeric buttons (direct tuning). If
you don't know the frequency of the station you want,
see "Receiving broadcasts by scanning stations
(automatic tuning)" on page 13.
Before you begin, make sure you have:
¢ Connected an FM/AM aerial to the receiver as
indicated on page 5.
* Selected the appropriate speaker system. (See
"Selecting the speaker system" on page 7.)
POWER Numeric buttons MASTER VOLUME
FM AM DIRECT TUNER
1 Press POWER to turn on the receiver.
2 Press TUNER.
The last received station is tuned in.
Press FM or AM to select FM or AM stations.
4 Press DIRECT.
Press the numeric buttons to enter the frequency.
Example 1: FM 102.50 MHz Example 2: AM 1350 kHz
Ee | Af Ca RO a | a
Cooee oboe
6 When you tune in AM stations, adjust the
direction of the AM loop aerial for optimum
reception.
To receive other stations
Repeat Steps 3 to 5.
o If the STEREO indicator remains off
Press FM MODE when an FM stereo broadcast is
received.