Installing Hook - Makita XWT19 Instruction Manual

Installing or removing drill bit/
socket adapter
Optional accessory
Only for Model XWT09 / XWT09XV
Fig.11
A=11.1 mm (7/16")
Use only the drill bit/socket adapter shown in the figure.
Do not use any other drill bit/socket adapter.
1
2
Fig.12
► 1. Drill bit 2. Sleeve
To install the drill bit, pull the sleeve in the direction of
the arrow and insert the drill bit into the sleeve as far as
it will go.
Then release the sleeve to secure the drill bit.
To remove the drill bit, pull the sleeve in the direction of
the arrow and pull the drill bit out.
NOTE: If the drill bit is not inserted deep enough into
the sleeve, the sleeve will not return to its original
position and the drill bit will not be secured. In this
case, try re-inserting the drill bit according to the
instructions above.
NOTE: After inserting the drill bit, make sure that it is
firmly secured. If it comes out, do not use it.
Ring
Country specific
CAUTION:
make sure that the bracket and ring are secured
and not damaged.
CAUTION:
for their intended purposes only. Using for unin-
tended purpose may cause accident or personal
injury.
The ring is convenient for hanging the tool with hoist.
A
First, place the rope through the ring. Then hang the
tool up to the air with hoist.
3
Fig.13
► 1. Bracket 2. Ring 3. Screws

Installing hook

WARNING:
for their intended purposes only, e.g., hanging the
tool on a tool belt between jobs or work intervals.
WARNING:
hook as too much force or irregular overburden
may cause damages to the tool resulting in per-
sonal injury.
CAUTION:
secure it with the screw firmly. If not, the hook
may come off from the tool and result in the personal
injury.
CAUTION:
securely before releasing your hold. Insufficient
or unbalanced hooking may cause falling off and you
may be injured.
10 ENGLISH
Before using the ring, always
Use the hanging/mounting parts
2
1
Use the hanging/mounting parts
Be careful not to overload the
When installing the hook, always
Make sure to hang the tool