Table of Contents
Advertisement
5. Remove the
4G WWAN card
6. Remove the
WLAN
card.
7. Remove the
memory
modules.
8. Remove the
M.2 2230
9. Remove the
M.2 2230 solid-state drive from Slot
10. Remove the
heat sink (discrete GPU)
11. Remove the
assembly-inner
12. Remove the
system
board.
About this task
The following images indicate the location of the power button and provide a visual representation of the removal procedure.
Steps
1. Remove the two (M2x2.5) screws that secure the power button to the palm-rest assembly.
2. Lift the power button off the palm-rest assembly.
Installing the power button with optional fingerprint reader
CAUTION:
The information in this section is intended for authorized service technicians only.
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following images indicate the location of the power board and provide a visual representation of the installation procedure.
or
5G WWAN
card, as applicable.
or
M.2 2280
solid-state drive from Slot 1, as applicable.
or
heat sink (integrated
frame.
2, if applicable.
GPU), as applicable.
Removing and installing Field Replaceable Units (FRUs)
93
Advertisement
Table of Contents
