Table of Contents
Advertisement
Quick Links
True to the Music
JX42 V2
Guitar & Amp Switcher
O
'
M
wner
s
anual
Radial Engineering Ltd.
1165-1845 Kingsway Ave, Port Coquitlam BC V3C 0H3
Tel: 604-942-1001 • www.radialeng.com
www.radialeng.com
Email: info@radialeng.com
Specifications and appearance are subject to change without notice.
Copyright © 2021 Radial Engineering Ltd.
Advertisement
Table of Contents
Related Manuals for Radial Engineering JX42 V2
Summary of Contents for Radial Engineering JX42 V2
- Page 1 Guitar & Amp Switcher ’ wner anual Radial Engineering Ltd. 1165-1845 Kingsway Ave, Port Coquitlam BC V3C 0H3 Tel: 604-942-1001 • www.radialeng.com www.radialeng.com Email: info@radialeng.com Specifications and appearance are subject to change without notice. Copyright © 2021 Radial Engineering Ltd.
-
Page 2: Table Of Contents
We encourage you to read through this manual to familiarize yourself with the many features available on the JX42 V2, allowing you to get the most out of this powerful switching device. If you have any questions that are not addressed by this user guide, please visit our website at www.radialeng.com for additional resources and frequently asked questions. -
Page 3: Overview
True to the Music OVERVIEW The JX42 V2 can be simplified by grouping its features into four main sections: the Instrument Inputs, the Amplifier Outputs, the Tuner Outputs, and the MIDI Input. 1. INSTRUMENT INPUTS INPUT-1 INPUT-2 INPUT-3 INPUT-4 GUITAR SELECT... -
Page 4: Features
AMP SELECT: Illuminated switch toggles between amp outputs A & B. The light for the amp select switch turns off when the Mute function is engaged on the optional JR-2 remote footswitch or via MIDI commands. Each amp output also features a corresponding LED which turns on to indicate which amp output is currently active. Radial Engineering Ltd. JX42 V2™ Owner’s Manual... - Page 5 IEC POWER: Connection for standard IEC power cable (included). 100V/240V operation for international use. MIDI IN: Standard 5-pin MIDI connector allows MIDI controllers to activate the inputs and outputs of the JX42 V2. Eight dip switches configure channel, program, and control changes. Can be used in conjunction with the JR-5 and JR-2 footswitches.
-
Page 6: The Instrument Inputs
Each output also includes a The amp outputs and lift switches LIFT switch that can further reduce ground loop noise should you encounter any during setup or soundcheck. JX42 V2™ Owner’s Manual Radial Engineering Ltd. -
Page 7: The Tuner Outputs
Both of the tuner outputs can be used simultaneously if needed, and they will always be active, even when remote footswitches or MIDI controllers are used to mute the JX42 amp outputs. The tuner outputs, mirrored on the front and rear panels of the JX42 Radial Engineering Ltd. JX42 V2™ Owner’s Manual... -
Page 8: Using The Jr-5 Remote For Guitars
• Use the footswitches 1 thru 4 to recall the four banks from the JR-5’s internal memory. • You can exit BANK mode at any time by holding the MUTE footswitch for 3 seconds, until the STATUS LED turns off. JX42 V2™ Owner’s Manual Radial Engineering Ltd. -
Page 9: Using The Jr-2 Remote For Amps
The JX42 ships with Dip switches 1-4: DOWN, 5-7: UP, and 8: DOWN. This configuration means the JX42 will respond to MIDI messages on all MIDI Channels, and the JX42 will respond to Control Change messages only. The default MIDI dip switch settings Radial Engineering Ltd. JX42 V2™ Owner’s Manual... - Page 10 This is helpful during initial setup and testing with your MIDI equipment. When switch 8 is in the DOWN position, the JX42 will only respond to dip switch changes after the unit has been power cycled. JX42 V2™ Owner’s Manual Radial Engineering Ltd.
-
Page 11: Specifications
GENERAL Conditions:....................For use in dry locations only between 5°C and 40°C Power: ....................100V to 240V, 50/60Hz with IEC connection Conformity: ...................CE, FCC Warranty: ....................Radial 3-year, transferable *Specifications are subject to change without notice. Radial Engineering Ltd. JX42 V2™ Owner’s Manual... - Page 12 RADIAL ENGINEERING LTD. 3 YEAR TRANSFERABLE WARRANTY RADIAL ENGINEERING LTD. (“Radial”) warrants this product to be free from defects in material and work- manship and will remedy any such defects free of charge according to the terms of this warranty. Radial will repair or replace (at its option) any defective component(s) of this product (excluding finish and wear and tear on components under normal use) for a period of three (3) years from the original date of purchase.