Table of Contents
Advertisement
GM-HSOO
Connecting the leads (supplied)
Connecting the speaker leads
This amplifier can select two-channel output (stereo) or one-channel
output (mono). The speaker leads must be connected to suit the mode
selected. Connect the speaker leads to the output terminals of the
amplifier, paying attention to the polarities <+ and -) and lead colors.
TWo-channel mode (stereo)
Sm*h kW
© « ©
© L ©
0—hi
©
t t t t
® © © ©
Speaker output
Speaker output
(right)
(left)
One-channel mode (mono)
•
Slide the drive mode switch to the left {Dynamic/Bridge).
Spwtor lafet
© * ©
© L ©
©—■*.—©
Speakers to be connected to the amplifier for one channel (mono)
If this amplifier is used for one channel (mono), its nominal output is 320
W (640 W max.). To handle this output, four identical speakers with
nominal inputs of 80 W or more should be connected as shown below
(making the total nominal inputs 320 W or more). The output volume
will be greater than when only a single speaker is used.
One-channel (mono) output
ID
Advertisement
Table of Contents
