Destination; Complete Set; Device Arrangement - Electrolux EWH SI EEC User Manual

6
www.home-comfort.com
Warning!
The installation of the supplied safety valve is
a mandatory requirement. Do not install any
shut-off valve between the safety valve and
the and the tank inlet, as well as blocking the
discharge port of the safety valve.
• Do not leave a water heater filled with
water without power and heating water
in a room where the temperature may be
below 0 °C.
• In case of long absences, repair,
technological and preventive work on the
water supply line, it is necessary to close
individual stop valves on the cold water
supply line to the water heater and on the
hot water outlet line, as well as to turn off
the water heater and disconnect from the
power supply by pulling the plug from the
socket.
• If any part of the water heater is damaged,
contact a service technician for repair. Use
only replacement parts supplied by the
manufacturer.
• This appliance is not intended for use by
persons (including children) with reduced
physical, sensory or mental capabilities, or
lack of life experience or knowledge, unless
they are supervised or instructed. Children
should be supervised to ensure that they do
not play with the appliance.

Destination

The electric storage water heater is designed
for heating cold tap water. It is used exclusively
The water from the water heater is not intended
for drinking or cooking.
Installation and initial start-up of the heater
must be carried out by a qualified technician,
who can be held responsible for the correct
installation and give recommendations on the
use of the heater.
Wiring must comply with current standards and
regulations.
Before installing the water heater, make
sure the grounding electrode of the outlet is
properly grounded. If the grounding electrode
is missing. The water heater must be grounded
by a separate grounding conductor to the
ground terminal on the heater element flange
fastener in the outlet. Do not install or operate
the product if grounding is not available.

Complete set

The electric storage water heater is complete
with the basic elements for installation and
connection. The water heater set includes:
• water heater with power cord — 1 pc;
• safety valve — 1 pc;
• RCD with instructions for use — 1 pc;
• fixing anchors for mounting.
For 30L, 50L — 2 pcs; for 80L, 100L — 4 pcs;
• user manual — 1 pc;
• warranty card (in the manual) — 1 pc.

Device arrangement

1
7
5 6 119
1. Hull
2. Dry heating element housing
3. Power cord with RCD
4. Cold water inlet
5. Hot water output
6. Control Panel
7. Hot water supply pipe
8. Electronic anode
9. Safety thermostat
10. Cold water intake pipe into the tank
(with diffuser)
11. A place for a speaker
12. Thermal insulation
Automatic water temperature control:
When you open the hot water tap on the mixer
tap at the water heater outlet, cold water starts
flowing in. The water in the tank mixes and its
temperature decreases. The thermostat sensor
reacts to the falling water temperature and the
heating element (heating element) switches
on automatically and heats the water up to
the set temperature. When the temperature
reaches the set point, the heating element is
automatically switched off.
12
2
8
3
10
4
Fig. 2