Craftsman 320.39589 Operator's Manual page 14

6. Lift up on the lever that
controls the front paper clamp
and lock it back into the
slot on the platen. This will
securely clamp the paper to
the front of the platen (Fig. 5b).
7. Smooth out the sandpaper
by pressing it tightly against
the bottom of the platen (front
to back).
8. Insert the back end of
the sandpaper into the
back paper clamp, fit the
Fig. 5b
Paper g__
under the clamp ,_'__ -"_
,
sandpaper as tightly as possible, and lift up on the back clamp lever to lock
it into place. This will securely clamp the paper to the back of the platen.
The sandpaper should now be positioned tightly against the underside of
the platen from front to back and securely clamped in place (Fig. 5b).
PAPER PUNCH
A paper punch is provided with the
sander so you can punch properly
aligned holes into the sandpaper.
This is done after the paper is
installed onto the sander.
To punch holes, line up the front
and side of the sander over the
paper punch as shown in Fig. 6,
then lower the sander onto the
punch template while applying
pressure. Make sure the holes are
punched all the way through the
paper and clear the holes in the
sander's platen.
Paper punch
NOTICE: Punching holes properly is a necessary step for the dust-collecting
system to operate properly.
Z4