Table of Contents
Advertisement
13. Unwrap Power Cord from Cord Retainer and
plug into 120 Volt, 60 Hz grounded outlet as
described in Important Safety Instructions,
page 2.
Cleaning
1. Slowly move the Bare Floor Cleaning Tool
back and forth over soiled surface one time
while depressing Triggei:
Do not overwet.
2. Repeat motion over same area without
depressing Triggei:
3. Repeat Steps 1 and 2 until no more dirt can
be removed.
4. If machine loses suction and/or noise rises in
pitch, turn Power Switch to OFF. Check the
Dirty Water Tank Assembly and empty the
tank if it is full (see WHEN YOU'RE DONE,
page 7).
5. If spray tip stops spraying, turn Power Switch
to OFF and check water and cleaning solution
levels. Refill if needed.
Never run POWERSTEAMER'M dry.
WARNING: The
Dirty Water
Tank
Assembly
holds
approximately
one
_allon
of soiled
liquid°
special
float device
in the tank will cause
the cleaner
to stop
relaoving
solution
from
carpet,
and the motor
sound
to rise in ?hch
when the Dirty Water
Tank Assembly
is full.
Failure
to empty
full
tank will damage unit.
WARNING: Do not
lay unit
on its back
with
Clean Water Tank Assembly
in place.
Do not tip up
Jbot with
Dirty Water
Tank Assembly in place°
1. Follow instructions in WHENYOU'RE DONE, page 7.
2. Disconnect Solution Tube Connector by turning it counter-
clockwise and gently pulling it straight from port.
3. Remove Flex Hose Assembly from Dirty Water Tank
Triangle port.
4. Replace Dirty Water Tank Triangle Lid.
5. Coil Flex Hose Assembly in Hose Rack on back
of POWERSTEAMER/M
6. Rinse Tools in clean running water, dry, and replace as
shown in HOWTO PUT IT TOGETHER, page 4.
7. Wrap Power Cord around Cord Holder on back of
POWERSTEAMER/M
8. Wipe all surfaces with a soft cloth.
9. Store cleaner upright in a protected, dry area.
NOTE: You may have water remaining in the Clean Water
Tank Assembly, and BISSELLFiber Cleansing Formula _M
remaining in the SmartMix :_dispenser. Never leave clean
water in the Clean Water Tank Assembly or soiled
solution in the Dirty Water Tank Assembly.
11
Advertisement
Table of Contents
