GE GLC4000 Series Installation Instructions Manual page 4

Installation Instructions
STEP 6 DISHWASHER WET TEST
(continued)
* Let dishwasher run through a complete fill - circulate - pump
out cycle. This will take approximately 5 minutes.
* Check for leaks.
* |f a leak is found, unplug dishwasher, correct as necessary
and then plug dishwasher back in.
* Open the dishwasher door and make sure most of the water
has drained. If dishwasher did not drain, check drain hose to
be sure it is not kinked.
* Let the dishwasher run through another fill and drain cycle.
Check again to be sure there are no leaks.
« At the end of the second drain set the control to the Off
position.
Timer Dial Models:
- Unlatch the door and rotate the timer dial to the Off
position.
Electronic Models:
- An electronic dishwasher run in Rinse Only cycle should
shut itself off after about 5 minutes of run time. No further
action is necessary if the dishwasher has turned itself off. If
the test was run in a cycle other than Rinse Only, push the
start pad one time and the dishwasher will reset and shut
itself off in about 90 seconds.
STEP 7 REMOVE POWER FROM
DISHWASHER
* Unplug the dishwasher.
* Feed power cord back into its storage location.
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE
GE Consumer & Industrial
General Electric Company
Louisville, Kentucky 40225
ge.com
STEP 8 REMOVE UNICOUPLE FROM FAUCET
* Relieve water pressure from the unicouple assembly before
disconnecting it from the faucet by depressing the red
pressure relief button on the unicouple.
* Depress locking collar and remove unicouple from faucet.
* Drain excess water from unicouple by holding it below sink
level and allowing excess water to run from the hoses into a
pan or similar container to catch the water.
* Feed the unicouple and hoses back into their storage pocket.
Depress collar to
release unicouple
from faucet
IMPORTANT:
Release water pressure from the unicouple prior to dis-
connecting the unicouple from the faucet. This will make it
easier to remove the unicouple and will prevent splashing as
a result of water rapidly escaping from the unicouple hose.
STEP 9 STORE DISHWASHER
* Latch dishwasher door closed.
* Roll dishwasher into its storage location.
© 2007 General Electric Company
Pub. No, 31-30250
Dwg. No. 206C1559P189
ND O7E-2357 (9/07)