Advertisement
2.
Insert the Attachment head into the
inner diameter of the bearing.
3.
Grasp the Attachment head while
turning the Handle clockwise until
the Attachment clamps open and are
snug against the bearing lining.
4.
Firmly grasp the Slide Hammer and
Handle with both hands. Spread
your feet shoulder-width apart.
5.
Gently push Slide Hammer forward.
Make sure your fingers are not in
the way of the sliding action.
Maintenance and Servicing
1.
BEFORE EACH USE, inspect the
general condition of the Bearing
Puller. Check for loose attachments,
misalignment or binding of moving
parts, cracked or broken attachments,
and any other condition that may
affect its safe operation. If any
abnormality is found, have the problem
corrected before further use.
Parts List and Diagram
Part
Description
1
Slide Hammer
2
Handle
3
Attachment 3/8" to 1/2"
3
4
5
6
Item 62601
For technical questions, please call 1-888-866-5797.
6.
Forcefully pull Slide Hammer backward
towards your body. Watch bearing
for movement. Bearing should pull
out evenly. If the Bearing pulls out
unevenly during this operation, stop.
Remove the Bearing Puller and gently
tap the bearing with a rubber mallet
until it is even, then start again.
7.
Repeat steps 4 thru 6 until bearing has
successfully pulled free of its location.
8.
Close the Attachment clamps by
twisting Handle counterclockwise.
Then remove the bearing.
2.
AFTER EACH USE, wipe off Bearing
Puller with clean, moist cloth.
3.
Lubricate Attachments regularly
to ensure smooth operation.
4.
Replace Attachment if threads
begin to wear and it will not
attach to Slide Hammer.
Qty
Part
1
4
Attachment 9/16" to 11/16"
1
5
Attachment 5/8" to 1"
1
6
Attachment 1" to 1-1/4"
Description
2
1
Qty
1
1
1
Page 3
Advertisement
