Table of Contents
Advertisement
1015
SONY/GENERAL
AUDIO
WED
13:59
FAX
201
930
7982
04/30/97
28
Maintenance
Cleaning the lens
If the lens becomes dirty, it may cause a
skipping of sound during CD operation.
Clean with a commercially available
blower.
Cleaning the tape heads and tape
path
Wipe the heads, the pinch roller and the
capstan with a cleaning swab slightly
moistened with cleaning fluid or alcohol
after every 10 hours of operation for
optimum playback and
i
quality. To make the best possible
recording, however, we recommend that
you clean all surfaces over which tape
travels before each recording.
Record/playback head
Capstan
Erase head
Pinch roller
mn
After cleaning, insert a tape when the
areas cleaned are completely dry.
Additional Information
u
ann
A AAA AA AS
eye
IÓ
Demagnetizing the tape heads
After
20 to 30 hours of use, enough
residual magnetism will have built up
on the tape heads to begin to cause loss
of high frequency sound and hiss. At
this time, you should demagnetize the
heads and all metal parts in the tape
path with a commercially available tape
head demagnetizer.
i
Cleaning the cabinet
Clean the cabinet, panel and controls
with a soft cloth slightly moistened with
a mild detergent solution. Do not use
any type of abrasive pad, scouring
powder, or solvent, such as alcohol or
no
se mes
A
A
RETTEN A
ale
A
A
e un
o
A
an
|
Specifications
AUDIO POWER SPECIFICATIONS
POWER OUTPUT AND TOTAL
HARMONIC DISTORTION
With 2,8-ohm loads, both channels driven
from 150 - 10,000 Hz; rated 2 W per channel-
minimum RMS power, with no more than
10 % total harmonic distortion in AC
operation.
Other Speciflcatlons
CD player sectlon
Compact disc digital audio system
Laser diode properties
Material: GaAlAs
Wave length: 780 nm
Emission duration: Continuous
Laser output: Less than 44,6 UW
(This m. po is the value measured at a distance of
about 200 mun from the objective lens surface on
the optical pick-up block with 7 mm aperture.)
speed
200 r/min (rpm)
to 500 r/min (rpm) (CLV)
Number of channels
*
2
Frequency response
20 - 20,000 Hz +1/-2dB
Wow and flutter
Below measurable limit
Radio section
lency range
FM: 87.6 - 108 MHz
AM: 531 - 1,602 kHz (Australian model)
530 - 1,710 kHz (Other models)
Aerials
FM: Telescopic aerial
AM: Built-in ferrite bar aerial
Cassette-corder section
Fast winding time
Approx. 120 s (sec) with Sony cassette C-60
Frequency response
:
TYPE I (normal): 70 - 10,000 Hz
AER
era sme
amy cr
General
Speaker
Full range: 10 cm (4 in.) dia.,
2.8 ahms, cone type (2)
Ontputs
Headphones jack (stereo minijack)
For 16 - 68 ohms impedance headphones
Power output
US model)
25 W +25 W (at 2.8 ohms, 10 % harmonic
distortion)
Power requirements
For CD radio cassette-corder
For CD radio cassette-corder:
220 V AC, 50 Hz (Australian model)
120 V AC, 60 Hz (Other models)
9 V DC, 6 size D (R20) batteries
Dimensions
Design and specifications are subject to change withow'
Optional accessories
Sony MDR headphones series
Additional Informatic
Advertisement
Table of Contents
