Table of Contents
Advertisement
5) Select menu "Auto", then select items "All chip", "program" and other switches as Fig. 5
6) Press key "Run" as Fig. 4 to begin burning software, there are two steps for the process: Erase
and Program, normal burning processes are as follows:
the first course "Erasing..., Flash Status :03" will be lasting for a moment, otherwise skipping
over means unsuccessful erasing; please confirm process (2) and then burn software again;
the following course "Programming... , Flash Status :00" will be done until a prompt "Pass" is
displayed.
7) A prompt "Pass" will be displayed beside the key "Run" for successful burning as Fig. 6
Fig. 4 Burning file
Fig. 5 Switches
12
Advertisement
Table of Contents
