Table of Contents
Advertisement
DEBUG
6) LED_C1 (RGB LED Strip Header)
PORT
The header can be used to connect a standard 5050 RGB LED strip (12V/G/R/B), with maximum power
rating of 2A (12V) and maximum length of 2m.
1
RGB
LED Strip
1
12V
For how to turn on/off the lights of the LED strip please visit the "Unique Features" webpage of
GIGABYTE's website.
Before installing the devices, be sure to turn off the devices and your computer. Unplug the power
cord from the power outlet to prevent damage to the devices.
7) SATA3 0/1/2/3/4/5 (SATA 6Gb/s Connectors)
The SATA connectors conform to SATA 6Gb/s standard and are compatible with SATA 3Gb/s and SATA
1.5Gb/s standard. Each SATA connector supports a single SATA device. The Intel
RAID 1, RAID 5, and RAID 10. Refer to Chapter 3, "Configuring a RAID Set," for instructions on configuring
a RAID array.
7
7
7
7
To enable hot-plugging for the SATA ports, refer to Chapter 2, "BIOS Setup," "Settings\IO Ports\
SATA And RST Configuration," for more information.
Pin No. Definition
1
12V
2
G
3
R
4
B
Connect your RGB LED strip to the header. The power pin (marked with a
triangle on the plug) of the LED strip must be connected to Pin 1 (12V) of
this header. Incorrect connection may lead to the damage of the LED strip.
DEBUG
DEBUG
PORT
PORT
DEBUG
DEBUG
PORT
PORT
SATA3
Pin No. Definition
1
1
1
GND
0
1
2
TXP
3
TXN
4
GND
SATA3
1
5
RXN
5
3
6
RXP
4
2
1
7
GND
- 15 -
Chipset supports RAID 0,
®
Advertisement
Table of Contents
